Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
I have a nRF5340PDK, Now I want to know the lowest power consumption of this chip in different condition, such as adv, connect, sleep. But I am not sure how to config the...
Hi.
I am testing sleep mode using nrf_pwr_mgmt_run().
When nrf_pwr_mgmt_run() is called, it is changed to sleep mode, but it wake-up up immediately and it is changed to...
Hi,
We are getting a request from our customer on supporting on NB-IoT PoC test cases as below.
Can you please let us know how we can simulate or execute the same?
...
I have written two methods to read and write value from fds.I get FDS_EVT_WRITE call back with p_fds_evt->result=!= FDS_SUCCESS
but when i try to read it after that it gives...
Hello,
I use the method, armgcc.
The commends "make flash_softdevice" and "make flash" echo the below. It seems OK. But I cannot see the app "/nRF5_SDK_12.3.0_d7731ad...
Hi,
I'm having a bit of a problem with using friend nodes in mesh networks. I have connected a friend for 2 nodes:
1, But I do not understand the real mechanism of the...
Hi,
I am trying to receive data using USB Custom HID.
Data reception is normal using "app_usbd_hid_generic_out_report_get", but the data size is always 64 bytes.
Is...
Greetings,
We are using nrf-sdk v1.3.0.
We would like to monitor an adc channel using either limit event monitoring or maybe LPCOMP.
I was able to find "low level" documentation...
i am using ble_app_gatts example as beacon observer ,till 10 sec after powering up device i need connectable advertise after that period ,as i switch the advertising from...
Can you do successive updates to a Notify Characteristic using sd_ble_gatts_hvs() during the same connection interval without losing data.
The question comes down to, does...
Hi! I've successfully set op an OpenThread MQTT broker using a Rasperry Pi and nrf52 dongle and I am able to publish and subscribe to and from my computer by flashing the...
