Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
trying to build a long range coded phy broadcast/scanning application. as I know zephyr doesn't support that so we have to include nordic link layer based on this post
https...
Hello all,
i am using ble_app_uart example.I add the line
in the begining of the main function. All the ble connection works, but putty shows strange characters...
I am having a bit of trouble getting high enough data throughput for my application so I have a few questions regarding it.
Can running the spi/other peripherals affect...
Hi，
I tried to build a BLE sniffer environment. And it works well to capture the LE secure connection air packet after Eable Secure Connections debug mode （uses the debug...
Hi,
using:
SDK for thread and Zigbee 4.1.0
NRF52840dk
I am trying to add UART (for my custom application) to an existing Thread example with CLI. (e.g. ble_thread_dyn_hrs_coap_srv_freertos...
Hi,
I'm really struggling with encryption, kind of lost in the woods of libraries, api's and documentation. Can anyone point me in the right direction?
Config: I have...
Hi support team,
i'm trying to build sercure bootloader on beacon nrf51822xxaa. I used SDK 12.3, here is my config
and i use nrf program to read flash infor
when...
Hello,
I am working on a Proteus III module which work with a nrf52840 SoC. I am using nrf52840 DK to test and develop code and at the same time testing the codes in the...
Does the nrf_cc310 support interrupt operation? I want to start the calculation of a hash/asymmetric signature but don't want that the CPU busy-waits until the calculation...
Hello,
I am trying to do make a connection with sd_ble_gap_connect();
First i am scanning all the devices arond and i am filtering with my functions using with ble_gap_evt_adv_report_t;...
Hi, I'm using nRF52832 Software Development Kit, PCA10040, S132.
I'm trying to connect the hrs central to my device and read the data from that. But the feature of my...
Hello, I am writing the firmware to the product in the J-Link and nrfjprog. The command is used in the same way as described in the Makefile, and is used in general. Normally...
Hi,
I'm trying to integrate the USB CDC ACM example into a project that I'm currently running on an NRF52840 DK with SDK 16.0. My PC is running windows 10 and python 3...
Hey, I'm trying to set up a simple timer that fires an interrupt every so often (100-200ms), but I'm having trouble. My interrupt keeps firing continuously, but I think I...
