Hi,
I have two CPU in our product. (STM32F2 and Nordic nrf51422).
I use serialization function to link those two CPU(refer to ble_s110_serialization sample)
But I find...
Hi,
My behavior is as follows
Turn on my device(use 51422) and advertising(2 Service and 3 Characteristic)
Turn on my cell phone(Samsung Note3),scan my device...
Hello:
I used analog IIC write MPU6050. Again after power download programs, mpu6050 can run up there ACK response. But the debug will not run. Simulation IIC because no...
Hello!
How can I communicate with my nRF24L01+ and nRF51822 at the same time. I can set up same channel, CRC-mode and I don't use ESB. But what about address? How do I set...
Hi all,
i want to know answer related to following question
1)what is use of uicr?
2)if i place some value in uicr and then change the image,then is there will be change...
It used to work, but now it says "Connected" but the rest of the GUI never changes and the mouse just shows a busy spinner. Here's the log file:
0;13:45:18.9900 [MainThread...
Hi all!
My question is:
My own application is built based on the example "ble_app_template", and according to the nrf51 SDK - Examples - BLE Peripheral, this example...
Hello
I'm using SDK 15.2 on nRF52 DK to test the ble_app_multirole_lesc example.
I downloaded the code to nRF52 DK to act as central.
I commented the scan_start() function...
I have two eval boards of nrf52832. I want to do BLE mesh between them. Can u provide me the link of the BLE Mesh SDK which open Segger embedded compiler.
### Details
MCU- nRF52832
DK- nRF52DK
### Description
Hi all,
I'm new to Nordic platform and this might come up as a very basic question but, I couldn't find...
Hi
I use a nrf52810 to implement a datalogger. I try to log sensor data to a SDCard. The firmware works fine to communicate with the sensor, but after I tried to insert...
Hi everyone,
My code flow is
1. Read Battery 2. Read Sensor
3. Send Data
4. Update Display
I want to know the time taken between the first step(Read Battery) and...
I am new to C programming and BLE in general.I am trying to create a service with two characteristics,(the application simply is a modification of BLE bulb and switch). How...
Hi,
How can I detect environment radio noise in each ESB radio channel?
Would you please give me a sample code which can detect environment radio noise?
Thank you...
I'm reading the SDK15.2 documentation coming from SDK 11. I've noticed the nrf_pwr_mgmt module, but I haven't seen it utilized by any of the examples. When should this module...
I implement basic Thermostat Zigbee device on top of FreeRTOS v10.0.0 with nRF Thread and Zigbee SDK in version v3.0.0 When there is no network to connect then after some...
I am working long nrf52840 and trying to implement long range in my project. There were examples in SDK 15.2.0 but i couldn't find any example or post which is related to...
Hey,
I'm using the nRF52840 dongle with SDK15.3. Am trying to make it a central device that is configured as a HID mouse when plugged. So I'm combining both multilink_central...
Hello everyone,
I got an issue with the custom board nRF52832 ( Raytac BLE module ) as I only achieve very short distance between the BLE device and Android app without...
Hi,Master:
When I use the QSPI library to communicate with flash, everything works fine. After a complete read and write, nrfx_qspi_uninit() is called to reduce power consumption...
