Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi Dev team,
I have been working on the Thingy91 and I had a question regarding using the kernel timers during runtime.
Is it possible in anyway to change the kernel timer...
Hi, Iam trying to use libuarte in ble_app_hrs code. I have two uart ports in nrf52833 in which uart1 iam using libuarte. Have made changes in sdk_config.h file and included...
Hi Team
I read the usbd_hid_generic in nRF SDK 16.0.0. The function hid_generic_idle_handler_set set a handler for idle reports. What is the idle reports mean? where descript...
Greetings,
we are writing a library for nrf9160dk, which is using PDM to read out microphone data from an extension module.
we are using NCS v1.5.0
To summarize the...
Hi guys,
I created an example for Mesh SDK where I defined my own header files. I called those header files in appropriate C files and tried to build and run a code but...
Hi ,
I am using nrf connect sdk , nrf 5340 dk board and segger studio. scanf is not working. please let me know how to use scanf for nrf5340 dk . can you provide me any...
How do I configure the chip to operate in radio mode or BLE mode on the same build?
It seems the radio mode example projects use no soft device, but the BLE project I want...
Hi guys,
I am developing the program for Mesh SDK where I will need to use different functionalities from different C files that I defined, into main.c. I have already defined...
so Im tring to use interactive command to output my personal content
same as the device command which out put the device message
but i want to find the function which...
Hi, Iam trying to integrate secure serial DFU over UART with ble_app_uart application. After integrating serial dfu code My application hardfaults at sd_softdevice_enable...
I'm trying the first steps of the initial tutorial with the nRF5340 kit, from here:
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fug_gsg_ncs%2FUG%2Fgsg%2Ffirst_test...
ERROR: JLinkARM DLL reported an error. Try again. If error condition ERROR: persists, run the same command again with argument --log, contact Nordic ERROR: Semiconductor and...
Dear sir,
Need to print RSSI value , What should i use SCAN_START() OR ADVERTISING_START () , WHICH ONE SHOULD I USE ??? AND WHAT IS THE PROPER EXAMPLE ON NRFSDK
...
HI
I'm in the process of evaluating nRF5340 but am new to Nordic chips and development environment. Im running Windows 10 and I installed nRF Connect 3.6.1 and installed...
