Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi
Is it possible to get any idea of timeframes for NCS being synced with upstream releases?
Zephyr have a public timeline for when releases will happen (sometimes not...
Hello,
In Nov 2020 I wrote a program for nRF52805 and it was working exactly as I expected it to.
Here is a small section of the code.
Basically, I just need to be...
Hi!
I'm trying to switch from SPM to TF-M in oder to use the secure processing environment. We currently use MCUboot + SPM for bootstrapping and DFU Image Manager for applying...
I was using Nordic Connect SDK v1.4.0, but put development on hold for a few weeks waiting for v.1.5.0. In particular I was waiting for openthread to be updated (which requires...
When I look at datasheet and reference designs for the nRF5340, I see a variety of approaches to DC/DC converter and bypass components. Is it a 10 uH inductor, or is it 10...
Hello Nordic!
I want to control the battery level, and set alarms... I know that there is a cluster callled PowerConfig cluster and I have been reading it, but I acan't...
Hello,
Sorry in advance if it sounds simple, i'm a beginner but I read AT command interface — nRF Connect SDK 1.5.99 documentation (nordicsemi.com) except that I can't retrieve...
Hi!
I'm currently working on a project thats based off of the nrf desktop keyboard. I'm using the Taiyo Yuden eysgcnzxx.
I just wanted to inquire the functionality of...
We have a Zigbee device that doesn't seem to use ZCL to transfer data and I have been trying to see if there is a way to get it working with an nrf52840 acting as a coordinator...
Hi, can we connect and enable the BME680 in the asset tracker code for the nRF9160DK?
It is already on the Thingy and I notice there is a switch CONFIG_BME680 in the code...
Tried to connect and Flash the hex file to enable BLE sniffing on the DK. However, the Connect desktop app was not able to detect the Development Kit.
All Steps mentioned...
Hello,
I am working on the Nordic nRF52840 development board to create a thread network and I want to use Raspberry Pi4 as thread board border router. The nordic SDK provide...
Following the insn here: https://devzone.nordicsemi.com/f/nordic-q-a/54591/nrf_serial_event_drv_err-what-is-the-cause
I found that under certain conditions, I get ERRORSRC...
Hi Nordic Community,
I have been experimenting with samples in NCS and making modifications.
Sometimes adding some code causes a hardfault during runtime. I can often...
Hello.
My application is an I2S Master that transmits audio data to an audio codec. I need to setup a transmit buffer using EasyDMA. Is EasyDMA used by default when using...
