Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi,
We are using NRF52832 MCU for one of our BLE based project.
We are running out of memory when specific operation performed. Buffer crashed.
What is minimum setting...
I was using log to print debugging information when the BLE_GATTS_CFG_ATTR_TAB_SIZE message popped up. It doesn't normally happen. What's the reason for that? Thank you very...
After flashing the nRF-9160-DK with the required firmware ( as instructed in this video https://www.youtube.com/watch?v=rMvW3HXLErk&feature=youtu.be ), the LED 3 is flashing...
Hello,
we need to disable UART0 to achieve low power operation of our device. This is done by running:
This works correctly on a minimal example when building using...
Hi ,
I want to know if it is possible to interface NFC text record example with ble_app_uart example. I want to run both the programs simultaneously. As the NFC text record...
Dear all,
The forum is full of questions around printing floating point numbers, however, I have a rather strange issue where maybe someone can help.
I have a project...
Hi,
I am new to creating project from scratch.
I want to use nRF51802 module. From few support tickets i have come to know that SDK version 12.3 and SoftDevice S130 version...
This is a beginner question and may well related to a misplaced setting in Segger Embedded Studio.
I am working towards a BLE scanner application which will include NFC...
Hi, Thank you for your attention to this matter.
Please provide nrf5340 layout in this package to me: WLCSP 4.39 x 3.994 mm package The customer needed to use this encapsulation...
I want to receive more than 250 bytes over NUS ,presently i have receiving All Data but in parts of 20 bytes (i.e after receiving 20 bytes BLE_NUS_EVT_RX_DATA event is occures...
Hi there,
I've recently purchased a nrf9160dk to evaluate. I've got some demo code going connecting via LTE and chatting to my AWS server via TCP and that's all going well...
Is there any SPI examples by directly accessing the registers?
Based on SDK15.0.2, for NRF52832 or NRF52810, higher freedom, higher memory utilization.
