Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
ot-br-posix commit mentioned in documentation does not exist:
https://infocenter.nordicsemi.com/topic/sdk_tz_v4.1.0/index.html?cp=7_3_0
https://github.com/openthread/ot...
Hi,
I am looking for Nordic development kit which has BLE and can also integrate a temperatue and promixity measurement sensor. Please suggest.
Regards,
Harish
Hello,
Sorry if my questions is already answered but I have been searching in this forum and google and didn't find any concrete answer.
I was wondering if there are any...
GPS sometimes suffers from slow searches. I want to get the location of the base station.
I'm trying to send AT+CEREG? , then get
+CEREG: 1,"1D2C","0D61D950",9,,,"00000010...
Hello,
I have some trouble programming nRF Thingy:91 and therefore would like to ask some questions about possibilities to flash the devices:
1) It is not possible to...
Hello,
I am trying to print Throughput using "ble_app_att_mtu_throughput" example application.
I have configured PHY at 1M (i understand it is 1 Mega samples per second...
I am trying to import a Keil project from SDK 12.3 following steps provided in this link: https://devzone.nordicsemi.com/nordic/nordic-blog/b/blog/posts/segger-embedded-studio...
We are experiencing some problems with our code and suspect it is an incorrect formatted printf.
Unfortunately the static code analysis in segger embedded studio (4.52c...
Development Software: nRF5 SDK v15.1.0
Windows 10, 64 bit
I'm following the instructions on how to install the micro-ecc library as detailed on the following page:
http...
I am sending task notification from nus_data_handler when in get BLE_NUS_EVT_TX_RDY event
In a seperate task , i am sending ble packets (244bytes) by using ble_nus_data_send...
Hi Team..,
iam using nrf52832 interface with quectel.iam using uart communication..the problem is when i transmit the AT commands nRF to Quectel that is working fine..but...
Hi,
I am trying to flash the hex file through j-link debugger on nrf52810 controller. Flash is done on hex file but not able to execute after done .
why this problem happening...
We plan to use NRF52805 in our existing boards to add BLE functionality. In the PCB guidelines of the NRF52805 there is a notification about the thickness of the PCB being...
