Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hi there,
I am using nrf52840, Softdevice S140,on our custom board. And my Android app is based on nrf android library( Andoid-BLE-Library )
Application is based on SDK17...
Hello All,
I am using nRF52840 Dev-kit and nRF5_SDK_for_Thread_and_Zigbee_v3.0.0_d310e71 SDK. So far in development, I have used the GPIO edge triggering method to detect...
hi support team,
i just tested http_application_update project, and i set up one server on cloud:"106.12.30.214:32500",
also you can reach this file server from web...
Dear Team,
We are developing an Vibration Sensing System, it contains nodes and gateway where all the nodes and gateway are present in the secured mesh network.
And...
Hi,
I'm using two boards with nrf52832 and sdk 15.3.0. One alter the ble_app_mult_uart__c example as ble center ，the othe alter the ble_app_uart example as ble peripheral...
Hi,
I'm testing heart rate measurement example with my nRF52 DK. In the nRF connect application, I see the logs are converted from Hexadecimal value to user-readable values...
Hi,
I was following the example posted on the below link.
https://devzone.nordicsemi.com/nordic/nrf-connect-sdk-guides/b/getting-started/posts/nrf-connect-sdk-tutorial...
Is it expected that the MQTT API does not receive any events unless a message is published to the server? I'm noticing that without a ping event or any message transmitted...
If I have a version 1.00 of my application which stores data in using flash data services . I make modification and version 2.00 of my application is a page larger.
1A)...
Maybe this is just a little nuisance but is there a difference pynrfjprog and nrfjprog ? There is no documentation on nfrjprog !
Searching infocenter for nrfjprog reports...
Hi,
trying for a few days now to generate a DFU zip file from the blinky example on a PCA10056:
nrfutil pkg generate --hw-version 52 --sd-req 0x9A --application-version...
We are in QA phase for launching the product. Our firmware is based on SDK v1.2 of nrf9160.
With the firmware, we have already tested the process in which the device is...
Hello!!
I am using transmitter example on my custom board having 10 buttons. I want to minimise the power consumption as it is powered by coin cell. I have used below tutorial...
