Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
some questions for power consumption of 52840.
We've planned to use about 10 to 30 nRF52840 devices for advertising TX mode. One scan mode device which is connected with...
I have a device based on the Nordic nRF52832. I am using softdevice s132. I am using Nordic nRF5_SDK_15.3.0_59ac345. My Android device I am testing with is running Android...
I recently bought a reel of nRF52840 and received rev C0 (Which is Engineering C). We require long range in our solution (Coded PHY). I was reading the compatibility matrix...
Hello,
I'm trying to stream data at ~ 30KB/s rate. I use nRF52840 development board with S140 as peripherial and smartphone with "nRF Connect" app as central. UART example...
Hello, Nordic.
A while ago, debug terminal do not appear in Segger Embedded Studio, and nothing happens when I click View -> debug terminal in the tab bar.
Currently...
As far as I understand, the nRF52840 USB dongle can be flashed via USB if there's a DFU capable bootloader installed (and it booted *into* that mode).
Once I got the dongle...
Hi
Good day!
I am new to this BLE module. I have worked out an application using nrf52 DK (nrf52832 SoC ) and now I want to use Ebyte module E73-2G4M04S1B which is based...
Hi team,
I am using nRF5_SDK_15.3.0_59ac345 and nrf52832 controller. I am using nRF5_SDK_15.3.0_59ac345/examples/ble_peripheral/ble_app_uart example code and the hardware...
Hello,
Please check my schematics with PA / LNA.
I have problems activating PA / LNA, the connection is very difficult when using the battery, I am forced to use external...
Hello,
Every time I try to run any example I download online for my nrf52832 board I get dependencies errors after locating the project folder to the sub "examples" folder...
I am trying to get battery % from the thingy91. I have the AT command AT%XVBAT running successfully. It returns what I assume is millivolts. However these value are higher...
When testing different applications on an nRF52840 dongle I have the following problem: The table of service and characteristics (1 service and 4 characteristics) of an earlier...
