Hi ,
I would like to know if a matching network is needed if I am only using a single external flex antenna for both LTE and GPS using a RF switch between them and a uFL...
I am a student interested in Nordic.
My coding skills are very poor.
So I want to get help.
I want to use the vl53l1x sensor in nrf52. (My ultimate goal is to measure...
I have a working project where pin 16 is configured as a low-level interrupt source.
it is working well with SDK 15.3
after porting to SDK 17.0.2, it is not triggering...
Hello Nordic Support Engineers and fellow developers ...
Just a note to thank everyone for help via this forum. I started very inexperienced with Nordic SDK a year ago and...
Hi,
I recently purchased a thingy91 for a project. I'm trying to follow instructions from a Nordic youtube video ( https://www.youtube.com/watch?reload=9&v=xQ7hDzRULJQ ...
I have a nRF5340PDK, Now I want to know the lowest power consumption of this chip in different condition, such as adv, connect, sleep. But I am not sure how to config the...
Hi,
we're developing a firmware for the nRF52811 that makes exhaustive use of RSSI sampling during packet reception. While this gives reliable results for Nordic proprietary...
Hello,
I'm currently using fatfs with a QSPI flash device on an nRF52840 with SDK 16. I was wondering what is the best way to put the qspi device to sleep in between reads...
Hi, i have a project with NRF52832 and i try to designing 2.4GHz antenna on PCB. I use your antennas as an example while designing, but whenever I try to simulate these antennas...
The company I work for wants to make a wearable personal (care)alarm device for use outside, think of an elderly person who is still mobile but is prone to falling. This device...
hi
All video I can found from youtube and nordic website :
(such as https://www.nordicsemi.com/Software-and-tools/Development-Tools/nRF-Mesh/GetStarted#infotabs )
are...
HI,
I'm facing a weird issue where the nRF52832 breakouit would reset and upon reading the RESETREAS reg, the value is 0xC or 0X8 ,I am using s132_nrf52_4.0.2_softdevice...
Hello,
I am using nRF52833, nRF Connect SDK v1.4.2.
I have imported the Zigbee light switch, light bulb, network_coordinator build and test it successfully.
I have also...
Dear Sir/Madam,
I have bought NRF52840 dongle to bring up my prototype as fast as possible. I am new to Bluetooth tech.
My application requires following peripheral...
Can we do CTL with dimming and generic on/off in nrf mesh app simultaneously. by using GPIO pins p0.15 and p0.16. for external leds. Is external led will get off. What will...
Hello there,
I am using nRD52840 PDK and nRF5_SDK_for_Thread_and_Zigbee_v1.0.0 SDK for BLE and Thread development. I am using examples from SDK. I have merged thread coap...
Hi, I am working on implementing the security aspect of our BLE application using nRF52832 MCU with SDK 17. The goal is to establish a secure connection between peripheral...
Hi，Dear all:
I got trouble when I change “libuarte example”(nrf52840 DK, SDK17.0.2)，the default example use RTC instance :
NRF_LIBUARTE_ASYNC_DEFINE(libuarte, 0, 0, 0...
Hello Nordic Team, Over the course of development I have had to reverse engineer and pick apart various sources (DevZone, Google, Zephyr documentation, etc) in order to figure...
