Hi to all Nordic product lovers,
This is not a question but rather an announcement of a new nRF52840 based finger tip size module 14 x 9 x 1.6mm launched at CrowdSupply...
Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hello,
I am trying to develop a set of code that will receive data on uart 1 and transmit that data on uart 2, and vice versa.
I have verified via testing printk's that...
Hi everyone,
First, my current environment is SDK 17.1, s332 v7.0.1 and nrf52832.
We recently have migrated from SDK 14 and we are still facing some problems, we have...
Hi. I have a problem, after upgrading the plugin nRF Connect for VS Code to a version higher than (2021.10.103) do not load modules of this plugin (photo attached). If I install...
Hello,
We are trying to setup the building environment for a nrf9160 device. We use the nrf Connect Desktop Toolchain for installing the environment and then we download...
Hi,
I want to connect to Google Cloud IoT with a modified asset_tracker and want the TLS done by the modem like in asset_tracker.
Google has a primary and a backup root...
Hi there!
After having worked with the nRF5 SDK and nRF SDK for Mesh, I'm off to a start for a project with LTE; CoAP to be precise. I'm using the nRF Connect SDK with Visual...
Hi,
I am working on a 2-wire uart to save GPIO and try to get as low current consumption as I can get.
Here is how I want it to be:
My custom 52840 board have 2-wire...
Hi,
I have created a custom board with a nrf52840 on it. I am working with Embedded Studio v5.64 and the Nordic SDK v. 17.1.0. When I use the preprocessor definition BOARD_PCA10056...
Hello Nordic experts,
Recently, I would like to implement high throughput with multi links. to optimize the system, I have the following doubts:
First of all, let...
I've recently put nRF Connect on my new machine, v1.7.0. I wanted to test the peripheral_uart sample application. However when I go to compile the peripheral_uart example...
Is it possible flash a nRF52833 over Bluetooth using the nRF52840 (PCA10059)? Or initiate DFU mode over Bluetooth using the dongle or a PC?
How could this be achieved?
In our application we want to connect to our server using LWM2M to exchange some data. To make a connection secure PSK key and indentity needs to be set to lwm2m objects:...
Hi,
I want to run my calibration code only once and this data store in flash (using FDS library) and not again even after restart. Is there any example of this kind of usage...
