Hi,
I am a bit confused about power consumption when using app_uart_fifo. To save power I put MCU to sleep in between each sent and received byte by using __WFE and __SEV...
Hi! I am building an android app for my project. I am using Proximity , UART and DFU from nrfToolbox app. I have 3 buttons on my home screen dedicated for each of them. I...
Dear Nordic employee:
1、 what do I have?
I have a thingy52 develop kit（nrf52832）
2、what is my purpose?
the quality of thingy52 audio demo is not good（iphone7）...
Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I follow the example, as below
nRF5_SDK_12.1.0_0d23e2a\examples\peripheral\flashwrite
but I only get some error, can not get anything, and the ble is unconnected.
Hi there. I'm making a sensor system which is intended to measure an ADC value, and send it using the Heart Rate Sensor template. To make this, I've rebuilt the ble_app_hrs...
Hi
Does the newly released nRF52840 chip have pins on the side, corresponding to the "outer ring" (A8-23, AD2-23, B1-W1, ...) pins on the underside of the chip, like this...
hello i am interfacing i2c sensor mma8452 with nrf51 dk. my function is
void mma_read(uint8_t *x, uint8_t *y, uint8_t *z)
{
uint32_t err_code;
uint8_t rx_buffer...
I have to sample 3 differential channels periodically. Should I calibrate SAADC for each channel individually? Unfortunately, "nRF52832 - Product Specification v1.0" doesn...
Update 2016-Mar-29: I used SDK v10 along with SoftDevice S110 v8 when I run the experiments described in this question.
Update 2016-Mar-30: Upload source code of the modified...
In order to perform dfu to softdevice S132 v3 sdk12 (secure bootloader) from sdk11 softdevice S132 v2 (legacy bootloader).I've change the legacy bootloader as it it says here...
by using Arduino mini pro 3.3v
I am planing to measure the temperature for the first five minutes, if the temp is over 40 degrees the device will send to Android app and...
Even though the SIG hasn't finalized yet and the 1.4.0 SoftDevice isn't out... Can we get a heads up on what to expect for 1.3.0 BLE 4.2 compatibility?
On something...
In arm_startup_nrf52.s (in the 8.9.0 device family pack), there is a new bit of code:
IF :DEF: __STARTUP_CONFIG
#include "startup_config.h"
ENDIF
I assume this...
Hi,
I'm thinking of using the NRF52 for an embedded wearable sensor application.
How much flash and Ram space can I expect to have remaining approx. for my application...
