I would like to source a compact BLE board to act as a lock controller developed with with a matching transceiver for use in a fob and an app.
It would toggle the pio and...
Ok so here is the issue. I was trying to build a simple application which is described in the tutorial for characters. After building an advertisement and understanding the...
I was working with IAR and SDK10.0 before. For some reason I have to transfer my project to Keil and SDK9.0. My program worked well for the old settings. While keeps got NRF_ERROR_SOC_NVIC_INTERRUPT_NOT_AVAILABLE...
Currently we are considering whether we should use external Flash Memory or NRF52 Internal Flash.
External Flash memory has a lot of drawback in comparsion with internal...
Suppose there are 10 BLE peripherals in a room and one BLE Central,then is there any way i can get the list of available peripherals[name or id.. etc]?
I am using NRF5182...
I am using SDK_11 s130 on nrf51-dk. When err_code is any value other than NRF_SUCCESS, APP_ERROR_CHECK(err_code) will cause nRF51-dk board to reset. How can one get APP_ERROR_CHECK...
Hello All,
I have problem with ble_app_uart which are not support DFU services.
When I am implement both services device will not advertise. and when ble_nus uninitialized...
Hi,
I have experience with the ESP 16/32, pi zero and BOSH XDK. I have been working on some IOT mesh stuff and I have a good product idea that I know I can build with your...
Our project is using SDK 15.3.0 on a nRF25840. Similar to this post , we'd like to be able to re-bond if the bond has been deleted on the Nordic side but not on the phone...
Hello,
I want to test nrf5340 external lfclk, but I don't how to test it.
sdk:1.5.0
board: nrf5340dk without hfclk
I want to use external lfclk to generate 1khz...
Hi Team,
I am developing a device using nrf52832. I want to configure the gpio used to wake up from system off mode to enter into gpio interrupt handler on wake up. How...
Hi ,
I need to add an I2C device in project , I referred sample project i2c_scanner .
changes done in nrf9160dk_nrf9160ns.overlay file
code added in prj.conf
...
We are using PPK II with nRF52840-DK and in zigbee case we are getting two different kinds of reparative pulses
1. Pluse_1 -> Amplitude = 17.52mA ; Ton = 200us & Toff =...
Hi All,
We found a problem about the NRF52832AA connect parameter update problem on some cell phones.
1. While the app connect to our device, parameter update not only...
I'm doing a load test on radio. In 1Mbps mode, the transmission time of the radio with different loads.
For a packet size of 65 bytes, I used this test:
Use the logic...
The crux of the problem is that my Zephyr I2C port is getting locked into EBUSY, and
What are possible reasons for this
How do I fix it
Context:
I'm currently...
Hello,
I am using an I2C sensor with my nrf52832 board and if I do the sensor_sample_fetch(dev), I get an error code of -16.
What does that mean?
Is there a table to...
