Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
I am installing segger embedded studio. the installation instructions are given at https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/nrf/gs_installing.html . I am...
Hello,
I am having trying to achieve hardware versioning via saadc.
Module model: nrf52832
Sdk: 15.2
There are two versions of the hardware:
version 1, there...
Hi,
I have PCA10059, its bootload is very handy, the customer can use the bootloader to upgrade the firmware for PCA10059 by serial port.
At this moment, I also want...
I am using ncs V1.5.1 and I can run the zephyr/samples/bluetooth/peripheral sample flawlessly on an nrf52dk_nrf52832 board. I verify BLE by viewing the "Zephyr Peripheral...
Hi, i have problem to import and configure the example with this sdk. I used the tutorial ( https://devzone.nordicsemi.com/nordic/nordic-blog/b/blog/posts/segger-embedded...
Dear Ladies and Gentlement,
I would like to read the 128bit UUID transmitted an iBeacon received on a S140 ble_central - just similarly as it is done with nordic App nRF...
I am using the NRF52 DK with Keil IDE in Windows. I uploaded the ble_app_uart_c example (Examples > ble_central > ble_app_uart_c) and modified it so that it would print a...
We are Developing a product using RF NRF24l01+ LNA+PA board. We are facing the problem of Range in Urban area we get only 100 meter.Is there any way to increase the range...
Hello I have a setup that work perfectly to debug applications but fails to work with the bootloader. I'm starting openocd, then gdb and issue the following commands that...
During the System On mode and System off mode, I see a spike in current of 400 uA with frequency of around 8Hz. Is it due to the refresh mode or is this different. Could anyone...
My SDK revision is 16.0, but our NFCT driver is programed by ourselves,didn't ues Nordic LIB. HW is also made by ourselves.
It often generates CRC error durring normal communication...
