Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi!
I'm trying to configure my NRF8001 module with the help of nRFgo studio. I'm using Nordic UART over BTLE service template. The module can be discovered via nRF Master...
Hello,
I'm currently using fatfs with a QSPI flash device on an nRF52840 with SDK 16. I was wondering what is the best way to put the qspi device to sleep in between reads...
Hi, i have a project with NRF52832 and i try to designing 2.4GHz antenna on PCB. I use your antennas as an example while designing, but whenever I try to simulate these antennas...
The company I work for wants to make a wearable personal (care)alarm device for use outside, think of an elderly person who is still mobile but is prone to falling. This device...
hi
All video I can found from youtube and nordic website :
(such as https://www.nordicsemi.com/Software-and-tools/Development-Tools/nRF-Mesh/GetStarted#infotabs )
are...
HI,
I'm facing a weird issue where the nRF52832 breakouit would reset and upon reading the RESETREAS reg, the value is 0xC or 0X8 ,I am using s132_nrf52_4.0.2_softdevice...
Hello,
I am using nRF52833, nRF Connect SDK v1.4.2.
I have imported the Zigbee light switch, light bulb, network_coordinator build and test it successfully.
I have also...
Dear Sir/Madam,
I have bought NRF52840 dongle to bring up my prototype as fast as possible. I am new to Bluetooth tech.
My application requires following peripheral...
Can we do CTL with dimming and generic on/off in nrf mesh app simultaneously. by using GPIO pins p0.15 and p0.16. for external leds. Is external led will get off. What will...
Hello there,
I am using nRD52840 PDK and nRF5_SDK_for_Thread_and_Zigbee_v1.0.0 SDK for BLE and Thread development. I am using examples from SDK. I have merged thread coap...
Hi, I am working on implementing the security aspect of our BLE application using nRF52832 MCU with SDK 17. The goal is to establish a secure connection between peripheral...
Hi，Dear all:
I got trouble when I change “libuarte example”(nrf52840 DK, SDK17.0.2)，the default example use RTC instance :
NRF_LIBUARTE_ASYNC_DEFINE(libuarte, 0, 0, 0...
Hello Nordic Team, Over the course of development I have had to reverse engineer and pick apart various sources (DevZone, Google, Zephyr documentation, etc) in order to figure...
Hello Nordic
I am using nrf52840, SDK 16.0,
I wish to implement Ble peripheral that advertise a connection request (if no response from central after x seconds then...
