Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi!
I'm trying to configure my NRF8001 module with the help of nRFgo studio. I'm using Nordic UART over BTLE service template. The module can be discovered via nRF Master...
To the kind attention of Nordic support team,
we are using your great sdk to evaluate nRF52840. We want to understand how to use every tool that can be
useful in production...
hello everyone I am trying to implement a Library from Arduino to nordic but I have a problem :
this is the Arduino code :
I replace by that :
But I Don't know how...
Is there any way to reduce the TWIM SDA line input current? We use a 1.8V I2C sensor (connected via level shifter) that can sink 2mA max. So, the communication will fail because...
hello Nordic
i work with nrf52832, sdk 16, s132.
I set a watchdog but when i try to create a fault by adding breakpoints after ble starts scanning then i get stuck...
ot-br-posix commit mentioned in documentation does not exist:
https://infocenter.nordicsemi.com/topic/sdk_tz_v4.1.0/index.html?cp=7_3_0
https://github.com/openthread/ot...
Hi,
I am looking for Nordic development kit which has BLE and can also integrate a temperatue and promixity measurement sensor. Please suggest.
Regards,
Harish
Hello,
Sorry if my questions is already answered but I have been searching in this forum and google and didn't find any concrete answer.
I was wondering if there are any...
GPS sometimes suffers from slow searches. I want to get the location of the base station.
I'm trying to send AT+CEREG? , then get
+CEREG: 1,"1D2C","0D61D950",9,,,"00000010...
Hello,
I have some trouble programming nRF Thingy:91 and therefore would like to ask some questions about possibilities to flash the devices:
1) It is not possible to...
Hello,
I am trying to print Throughput using "ble_app_att_mtu_throughput" example application.
I have configured PHY at 1M (i understand it is 1 Mega samples per second...
I am trying to import a Keil project from SDK 12.3 following steps provided in this link: https://devzone.nordicsemi.com/nordic/nordic-blog/b/blog/posts/segger-embedded-studio...
We are experiencing some problems with our code and suspect it is an incorrect formatted printf.
Unfortunately the static code analysis in segger embedded studio (4.52c...
Development Software: nRF5 SDK v15.1.0
Windows 10, 64 bit
I'm following the instructions on how to install the micro-ecc library as detailed on the following page:
http...
I am sending task notification from nus_data_handler when in get BLE_NUS_EVT_TX_RDY event
In a seperate task , i am sending ble packets (244bytes) by using ble_nus_data_send...
