Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi!
I'm trying to configure my NRF8001 module with the help of nRFgo studio. I'm using Nordic UART over BTLE service template. The module can be discovered via nRF Master...
Basically the same question as here:
https://devzone.nordicsemi.com/f/nordic-q-a/45557/getting-status-messages-from-mesh-to-phone
But the answer there doesn't really tell...
Hi Team
we are trying to use the example given in SDK 16.0 and I am able to write and read properly.
But when I want to write/erase my eeprom entire page (256-byte Page...
Guys:
I´m developing my own board with nordic 52382 and I´d like to know if a series resistor needs to be connected to SWDIO and SWCLK lines on board to connect to SEGGER...
Hello
Is any tool available for dynamic code analyser which supporting the ses project?
I have nrf52840 freertos project. I want to check my code for memory leakage and...
hi,
I am working on nrf52833 dfu. right now I received an error
raise NordicSemiException('Extended Error 0x{:02X}: {}'.format(resp[3], data)) pc_ble_driver_py.exceptions...
Hi,
I am working with Ubuntu 16.04 TLS.
I downloaded the "nrfconnect342x8664.AppImage" file and installed the .deb package of JLink_V682g.
When I start the "nRF Connect...
1.1. In function: poll (fds, ARRAY_SIZE (fds), cloud_keepalive_time_left (cloud_backend) ); How to detect actions that perform socket disconnections locally.
2. I queryed...
I faced several troubles when I worked with Bluetooth: Mesh sensor client and Bluetooth: Mesh sensor server examples. Firstly, I couldn't build the application "Bluetooth...
Hi, i want to flash my modified code in my customized boards , which hex file should i use for flashing the customized nrf52832 board usinf nRF CONNECT . I need a hex file...
Environment:
DSL-Router, IPv4 only, DHCPv6 disabled
Raspberry PI 3B, RaspPi_OT_Border_Router_Demo_v4.1.0-1.alpha.img, the raspberry is connected via wire with the dsl...
Hello,
I've been running some power measurements on our prototype board that is using the nRF9160. I've measured current draw on the VDD and the VDD_GPIO when the modem...
Hello ,
I am currently working on NRf52810 , SDK version 16 , I want to send around 400 bytes of data over BLE connection from peripheral to central. I know that NRF52810...
Hello, I am working for a BLE central application where the packets are send using L2CAP Connection-Oriented Channels. My development environment is based on nRF52 development...
