Hello,
I have a device based on nRF51822 revision 2 and SoftDevice S110 v7.1.0. Because it is revision 2 it is affected by PAN44 and PAN45, and by default the SoftDevice...
Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
I have two nrf9160, one with modem firmware 0.7.29-alpha and the other with modem firmware 1.0.0. With the latest firmware the search for LTE-M network fails while with the...
Hello,
We use NRF52 and the SPI protocol to read the ADS7866. But we are facing a problem when reading at high speed, we want to make one read transaction of 2 Bytes every...
Hi everyone,
in our project we transmit from an android app to Nordic BLE big amount of data (up to 180.000 bytes). I do it by using hvx notifications (MTU 247) and each...
I am trying to get nRF52832 working with Segger Embedded Studio. All the examples happily compile and load and run on the board.
But, I want to write my own basic hello...
Hello, I'm using SDK 15.3.0 throughput test and I want to change TX power to +8dBm. In documents it says change the power from sd_ble_gap_tx_power_set but I couldn't find...
Hi everyone,
I'm using the nrf52832 Dev Kit PCA10040
SDK version: 15.3.0
OS: Fedora
I try to use DFU following this tutorial but I can't see my application on...
Using SDK v11.0 and SD v2.0.0 on nRF52832 with ARM GCC.
I want to copy page(s) content to another page(s), I tried the following but couldn't succeed.
When I used the...
Hi,
I am using nRF9160 DK with Zephyr RTOS and able to successfully build asset_tracker in SES with the help of getting started tutorial. But I have getting problem to send...
Hello there,
I have used the nRF52840 DK to find the rssi values of all peripheral devices using the interactive example. I would like to create a command to find the rssi...
Hi,
I am developing sensor products with zigbee (nrf52840).
I have successfully test that sensor data is received by coordinator.
Network is as follows.
ZC(1)...
Hi,
I have a project where my nrf9160 is able to enable and get a fix with GPS and turn in on and off. I am trying to enable LTE when the GPS is off. Here is my procedure...
