I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hi, currently I use nRF Connect v3.0.0 to flash my nrf9160-DK. With the Segger Studio from Nordic I am able to generate the merged.hex but now my problem: I erased the chip...
Hello
I would like to compile Direct Test Mode on Segger embedded Studio.
I follow all instructions with getting started assistant
but i have one error : error 5 cannot...
I am starting with the nRF52-DK. Page 8 of the documentation has links for examples to get started.
4 Start developing After you have set up the development kit and installed...
Hi,
I get the problem when I tried to download ncs
west update WARNING: Can't set ZEPHYR_BASE: parsing of manifest file failed during command update : no "manifest...
Hello, everyone, I have an issue where I could use some help!
I have this setup.
- One nrf52840 ble peripheral (the data collector) that accepts multiple central connections...
Hello all.
I am developing a BT4.2 compliant application. I have a question about LESC (LE Secure Connection).
devzone.nordicsemi.com/.../how-to-implement-ecc-functions...
I am using the custom_bluetooth_service tutorial from https://github.com/bjornspockeli/custom_ble_service_example . I am trying to set the value length of the custom characteristic...
Hi,
I've been trying to connect nRF9160 DK to google cloud by running "google_iot_mqtt" following the directions here https://devzone.nordicsemi.com/nordic/nordic-blog/b...
I use SEGGER step-debug commands F5, F10 and F11.
Sometime F10 cause the debugger to step into disassembly code, making continue debugging hard.
Restart debugging 'cause...
Hi, I have an nRF51822 with s130 doing normal advertising and a Nordic UART service. Is there an example somewhere of doing some simple observation with it at the same time...
I am using the custom_bluetooth_service tutorial from https://github.com/bjornspockeli/custom_ble_service_example . However, I now want to try increasing security settings...
Hello,
I'm not sure it is a good place to ask the this question here. I have also asked this at zephyr maillist, but till now no one can help me.
I've found that the NRF9160...
Hi, I am using nRF52 DK with SDK 15.2 and SD132 for my project and use "ble_app_uart" as a reference. In my project, I want to start and stop advertisment manually through...
