[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
Hi Guys,
I have a MCU RTOS project. in Hardware board, builtin Nodic BLE chip over UART,RTOS BLE stack works fine.
We also have a MCU RTOS Emulator based on Qemu,we...
Hello,
I would like to have more info about canceling the pairing request on iPhone (thru the popup that asks if you want to pair with the device which is managed by iOS...
Hello everyone, I'm severely struggling to perform a simple task. I must be missing a very simple answer and, I hope with your help that I resolve the issue.
I am trying...
if the issue can be worked ,how to do that with android source code? the 2 ble pure devices (not android phone) connect with a ble android phone.
please check below, the...
Softdevice Version： 8.0.0
SDK： 9.0.0 IC：
NRF51822 Rev 3
service： NUS ANCS
When the application is not downloaded, the bootloader is working.
After serial bootloader...
Hello Everyone,
In my project, I am using NRF52832 in my custom board, all function tasks are working fine but when it comes to OTA, the firmware file is transferred to...
hello everyone,
I am designing a device which is operated with coin cell battery, I want to turn on & turn off a device using single button. when device in on mode it should...
Hi,
We are considering a modem delta FOTA on our 9160 devices in field, but find two "approaches" described to this; Either using the modem AT command set ( AT #XFOTA=2...
Hi, Im using a custom NRF52811 board and on this board we are using the internal RC as LFCLK source. I have a single thread that sleeps every 10 seconds, so during 10 seconds...
Hello Nordic,
Currently, we are looking the stack architecture of the BLE provided in the attached link https://docs.nordicsemi.com/bundle/ncs-latest/page/zephyr/connectivity...
Hi I am currently working with nrf5340 board to create Custom BLE profiles for data transfer to mobile app. I am not finding any document or videos that gives me a detailed...
Hello,
In an application with the nRF52832, Softdevice and SDK 17.1.0 I try to use the temperature sensor according to the peripheral example. I attach the temperature.c...
Hi,
when I have the nRF Connect for VS Code Extension Pack installed locally it will break Dev Containers. The following error message will be shown when I try to run...
Hello everyone,
I'm trying to use the buttonless dfu functionality on nRF52 DK. However, I can't seem to test the functionality when there is no bootloader flashed, but...
Dear sir/madam
I'm designing the custom PCB for bluetooth application. I have some doubt on 50 ohm RF line. How to maintain that 50 ohm in track.
Kindly support regarding...
Hi, I have followed the nRF Connect SDK Fundamentals and BLE Fundamental courses and come to Lesson 6 Bluetooth LE sniffer. Everything has worked until this but now I get...
Hi,
In nRF52811-CAA chip, which pins are allocated to ADC inputs. In Table 122 of datasheet which shows pinout for WLCSP package, it just mentions AIN1, AIN2, and AIN3....
