[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
Hi Guys,
I have a MCU RTOS project. in Hardware board, builtin Nodic BLE chip over UART,RTOS BLE stack works fine.
We also have a MCU RTOS Emulator based on Qemu,we...
Hello,
I would like to have more info about canceling the pairing request on iPhone (thru the popup that asks if you want to pair with the device which is managed by iOS...
Hello everyone, I'm severely struggling to perform a simple task. I must be missing a very simple answer and, I hope with your help that I resolve the issue.
I am trying...
if the issue can be worked ,how to do that with android source code? the 2 ble pure devices (not android phone) connect with a ble android phone.
please check below, the...
Softdevice Version： 8.0.0
SDK： 9.0.0 IC：
NRF51822 Rev 3
service： NUS ANCS
When the application is not downloaded, the bootloader is working.
After serial bootloader...
Looks like pc-ble-driver connectivity (hex file) firmware is limited to MTU of 250 via NRF_SDH_BLE_GATT_MAX_MTU_SIZE. We need to use MTU 515 to match what is supported by...
Hello,
Please forgive my dumb question but you'll save me so much frustration if you can help. I've been trying for 48 hours already.
I've just bought the nRF52 Development...
Hi everyone,
I am desing my own pcb using nRF52840 SOC. Looking the reference design I can see two external crystalls one 32.768kHz and one 32MHz.
1. The 32.768kHz is...
The reverse task is easy: Central can read service 0x1800, attribute 0x2a00 from peripheral. Central can obtain peripheral name from advertising data...
But how peripheral...
I'm using sdk15.0.0 and device nrf52840
I have 5 services among them only 1 service is for notifications and remaining services for reading and writes functionality. ...
Hi,
I build an Xamarin bluetooth application and I needs Plugin BLE nuget package Service, Characteristic and Descriptor UUID numbers. My device is nRF52840. I would like...
Hello everyone,
I am using UART in my project to send data and receive data
the issue is while I am debugging it shows or indicating at NRF_BREAKPOINT_COND;
but led...
Hi everyone,
I am developing a custom PCB that will integrate the nRF52840 SOC. More specifically I will use the MDBT50Q-1MV2 module from Raytac that is approved by Nordic...
I am working on nrf51822 and SDKV10, Softdevice S110. Firmware has implemented whitelist features and enabled bonding.When i bonded the device using nrfConnect App and the...
Hello,
My home application requires standard Wifi 2.4/5Ghz and Bluetooth 5 protocols for communication. I see that nRF has a proprietary Wifi, what are the differences ...
Hi need to change configuration which uart is used when mcuboot is going to serial recovery mode. I would like to have this set for uart1 by adding: Then I put nrf91 in the...
Hi, our product is one set of transmitter/receivier based on nRF24 series. Recently, the number of failures of receivers increases quickly, and most of failures are shown...
