Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hello, I'm working with the EK PCA10003, that has the NRF51422. I'm trying to read the information of the accelerometer MPU6000 with an ISP interface. At the moment I cannot...
Hello
I would like to point out that I have no knowledge of electronics.
I am in the advanced stages of building a project on the basis of Adafruit feather nRF52832, The...
I am trying to test the fatfs example (SDK14) using the 10056 DK.
I do nothing modification and it results in...
<info> app: FATFS example started. <info> app: Initializing...
I realize I am like the hundredth person to have this problem but all the solutions I have found don't seem to work.
I am trying to add a simple header file to the nordic...
I am new to Nordic, I am able to compile and run examples on nRF52-DK.
I know there are examples are done for us but how I can develop my own project which use multiple...
I just replaced SDK 14.0 with the shiny new SDK 14.1 in my project. My project uses components from the SDK, but I don't use the exact same structure. Once again, it won't...
My Environment
Nrf52840
SDK : nrf51_15.0.0
soft device : s140
Target : Scanner (central)
I am trying to set GAP parameter for listening single channel that is...
i use sdk14.2 52832 i use uart
UART0_CONFIG_USE_EASY_DMA =1 consumption ~2.1mA
UART0_CONFIG_USE_EASY_DMA =0 consumption ~650uA
Is this a normal phenomenon, is it true...
Hi,
I have a Development and Evaluation board by Waveshare and i have a nRF51822 board. I have downloaded the nRFgo studio and i have used a USB to UART board and connected...
Hi
I am developing an application where nrf52 acts as a BLE central
Specifications requires that this node should connect to a peripheral with a specified name, obviously...
I have 2 services are running using 16 bit UUIDs and now I am adding another service using our_service.c and our_service.h files but my program is crashing and leading to...
Hi Everyone,
I want to use the QSPI protocol to write data into the external 64Mb of Flash memory provided onboard of nrf52840 PDK.
I am able to run the QSPI example alone...
Sorry Nordic engineers , I'm asking urgently , goods need to come out quickly
chip：nRF52810
SDK：nRF5_SDK_15.0.0_a53641a
examples：ble_peripheral \ ble_app_uart
external...
