We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello,
I'm trying to create a PC application to read out some Ti Sensor Tag modules. I'm using a nRF51822 USB dongle and the Master Emulator api.
The nRF dongle sees...
Hello,
I have some trouble programming nRF Thingy:91 and therefore would like to ask some questions about possibilities to flash the devices:
1) It is not possible to...
Hello,
I am trying to print Throughput using "ble_app_att_mtu_throughput" example application.
I have configured PHY at 1M (i understand it is 1 Mega samples per second...
I am trying to import a Keil project from SDK 12.3 following steps provided in this link: https://devzone.nordicsemi.com/nordic/nordic-blog/b/blog/posts/segger-embedded-studio...
We are experiencing some problems with our code and suspect it is an incorrect formatted printf.
Unfortunately the static code analysis in segger embedded studio (4.52c...
Development Software: nRF5 SDK v15.1.0
Windows 10, 64 bit
I'm following the instructions on how to install the micro-ecc library as detailed on the following page:
http...
I am sending task notification from nus_data_handler when in get BLE_NUS_EVT_TX_RDY event
In a seperate task , i am sending ble packets (244bytes) by using ble_nus_data_send...
Hi Team..,
iam using nrf52832 interface with quectel.iam using uart communication..the problem is when i transmit the AT commands nRF to Quectel that is working fine..but...
Hi,
I am trying to flash the hex file through j-link debugger on nrf52810 controller. Flash is done on hex file but not able to execute after done .
why this problem happening...
We plan to use NRF52805 in our existing boards to add BLE functionality. In the PCB guidelines of the NRF52805 there is a notification about the thickness of the PCB being...
SDK: 17.0.0
Softdevice : S140
Example: ble_app_blink
I modify this example to long range adverting mode,and have some questions as follow:
(1) the device can not connect...
Hi there,
I'm working on a Zigbee project and I'm using the nRF5 SDK for Thread and Zigbee v4.1.0. For benchmarking purposes I need to read the number of hops a Zigbee-packet...
