Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi Team
I try to change the TX power in NCS with soft device control. I follow the example code of \samples\bluetooth\hci_pwr_ctrl. And I add the some test code in function...
I am going to use the BLE beacon function for simple home networking.
The device should be able to switch between beacon transmission mode and beacon reception mode (beacon...
I'm trying to get our mouse to connect to the dongle and it's not working, so I'm troubleshooting.
I noticed that I get 3 of these <err> bt_hci_core: Failed to add IRK to...
I am running into an issue around flash management when attempting mesh coexistance with BLE.
The call I am failing on is during mesh_init().
Line 298 of flash_manager...
Hello,
I'm making an application that I want to have the following behavior:
1) 52832 starts in sleep mode
2)P0.14 pulls to LOW which brings out of sleep mode and...
Hi
I'd like to use NB-IoT in Switzerland.
According to https://www.gsma.com/iot/mobile-iot-commercial-launches/ there is support for both LTE-M and NB-IoT in Switzerland...
Hello, I am working on the NRF9160DK and I have an issue with the asset tracker sample. Firstly, I followed the guidelines explained in the video "Unbox and get your Nordic...
hi support team,
i have ESB project for customer, and now i have one fundamental question about RTC cc compare event, i am struggled in this problem.
static __INLINE...
Hi,
I'm working on direction finding with nrf52833dk (my own board latter on) and Nordic antenna matrix. I'm using NCS v1.6.0-rc2 and example Direction fing connectionless...
Hello there,
I'm facing inconsistency across two nrf51 PCB boards in term of sending the device name. I'm running the same exact code on both. One is advertising the device...
As shown in the provided picture, the download worked after connecting, but the function does not work.
I have checked the following. 1. Check the operation status of...
Hi,
there are couple of examples on NCS with edge impulse. I would like to know how much space edge impulse add to the application, and to see if it can fit into nRF52840...
I have a customer that is using the nRF9160 embedded into their own device. Need to know if the nRF9160 is a module in which case the customer's end device will need to be...
