Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hello Nordic Engineer,
Actually, the phones are not part of the mesh network, right? Also, I treat all the nodes inside the red box as LEDs because I'm designing...
My own 52833 board use QFN40 package. DK use aQFN73 package.
I try the same code. and find DK can enable exernal xtal. while my own board cannot enable external xtal.
...
Hi,
I have an Adafruit feather nRF52840, and try to program it via a Nordic DK (through the connector Debug out). It is possible to flash the feather when I use a devicetree...
Hi support team,
I'm currently developing a project for a custom board with a nRF9160 chip and with nRF Connect SDK 2.9.0 and Zephyr 3.7.99 using VS code with nRF connect...
Hi, I'm implementing the DFU for the nRF5340 MCU and now need to set my private keys to be able to sign firmware files.
The issue is related to the Signature key file specification...
Hi,
The nrf connect for desktop extension in VS code is not loading anything under welcome, when I try to open the documentation or any other nrf related command it says...
Hello Nordic Engineer,
I tested the mesh functionality with one phone and the 52840 DK, and the DK is running the official mesh_light example. It worked successfully,...
Hi
I have a fully functional addressable LED driver interface using I2S + app_timer. This code has been functional for a long time by itself.
I just added the SAADC example...
First to contextualize my situation, I am in Brazil, more specifically in the city of São Paulo. When the development kit arrived, I immediately did the recommended initialization...
I am trying to send data from icm20948 sensor from the sensor node to the observer node using ble mesh. Due to the data from icm20948 is too large (9 uint16_t, 18bytes) for...
Hi Nordic community, I have received nRF7002DK device and trying to make it work on v2.9.0 sdk. I'm working wifi sample project,successfully building and flashing in the device...
I have installed the nRF Connect SDK, with both the toolchain and SDK set to version V2.9. I selected the nrf54l15dk board for development, but I do not have a physical nrf54l15dk...
Hello ,
I have taken reference project which use all leads and buttons of Evaluation module NRF52833.
I want to create overlay file for this project and remove few led...
