I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
I use a app_timer_create() function to create a task(200ms once)
when in the task_timeout_handle() ,
I do something more than 200ms,
what will this timer going ?
Hi!
I use nrf51-pwm-library ( github.com/.../) to control brightness of LED RGB light source and it works ok till I don't want to adjust brightness slowly (dimming function...
hello,
are there any completed sample code of using pwm0, 1?
just 2 or 3 word can working like following? or need other config?
pwmcon=xx;
pwmdc0=xx;
pwmdc1=xx;
also...
I want to achieve: 1. Mobile application networking with multi-lamp mesh 2. After mesh networking, many smartphones control all lights independently through proxy nodes. I...
Hi,
We are using nRF52832 based module on which we are using HCI over UART functionality with the help of Zephyr(v1.14.0) SDK to find the nearby beacons via Bluez stack...
Hello there,
So we are working with a sensor that needs to receive a pulsed voltage, so we are using a PWM signal from our nrf51-DK applied to a transistor based circuit...
I want to be able to read the gyro and accelerometer values from the MPU6050 sensor.
As a base start I downloaded the nRF5 SDK v15.3.0 and modified twi_sensor_pca10056 program...
Dear support,
We have built a ble mesh network running the light_switch_client/server application (mesh sdk 3.1.0). We are using the Android application for provisioning...
I want to disable and enable interrupts for Rx data, I tried following code to disable interrupt for rx and disable rx. Also TX and RX pins are short, i.e. loopbacked. In...
Hi,
I was wondering if I could get some guidance (or directed to some documentation on the subject) with regards to what socket operations are safe to do in a-sync timer...
I'm trying to use LTE and GPS in the same project. I know I cannot have LTE and GPS running concurrently, but I tried implementing edrx so I could get a GPS fix and alter...
Hello!
I bought recently some nRF52840 (PCA10059) dongle's and one nRF52840- DK. I want to create a kind of network ( a mesh network) from those dongles and communicate...
I cannot see CRASHLOG with RTT viewer but can see CRASHLOG dumps when SES ide debugger is running.
Is there anything different from the SES ide debugger's dumb terminal...
Hi I am working on modify proxy client switch example from mesh sdk version 2.i done some significant changes into code for sending string message rather than 1 or 0.but when...
HI,
AT command not working when network mode is "NB-IoT" in "mqtt_simple",
If network mode is "LTE-M" then AT command is working fine.
Snapshot with network mode is...
