Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Hi All
I am doing a BLE based project using nRF51822.Where i need to handle the message [with UUID] by using ble_gatts_char_handles_t.
so, can any one please share information...
I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples.
I've modified them to run on the PCA10001...
Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
Hi Nordic,
As far as I can see, there is no nrf5340 board support in nRF Desktop application in NCS 1.5.1. May I ask, is there a plan to support it? The nrf desktop gaming...
Hi!,
We are in the process of developing BLE Mesh for Lighting applications. We are currently working with nRF52840 DK. We have successfully tested BLE Mesh models for 1...
Hello
My application is based on the ble_thread_dyn_mtd_coap_cli example which allows to use Thread and Bluetooth in parallel. I would now like to secure the bluetooth connection...
Hello!
I have followed nrf connect sdk tutorial part3 and have walked through for bme280. But now I want to connect two or more bme280 sensors to my dk. How should I modify...
Hello,
I have an application where a BLE central connects to a BLE peripheral. Then the devices do the bonding procedure. After the devices are bonded the peripheral should...
I am testing the nRF9160 DK (PCA10090 with PIN) on the Bell Canada LTE-M, run into some problem and will appreciate some help.
At the beginning, the newest demo asset tracking...
Hi,
For Direct Test Mode on nRF Connect for Desktop, I have confirmed that Constant carrier can be selected.
The log was obtained at the time of the following settings...
NCS Release v1.5.1 now supports PA LNA, couldn't see any BLE examples on how to configure and use PA/LNA. could you provide any instruction/guidelines on how to enable/use...
Hello.
I'm using the NRF52832 with I2S module connected to TLV320DAC from TI. I've configured the DAC and I2S module successfully. I'm getting audio output (simple sine...
Hello,
I hope you are well.
I am currently working on interfacing an INTAN RHD2164 chip with the NRF52840. This chip is connected in SPI with the NRF52840. The only problem...
I tested NB-IoT and MQTT in NRF9160, and the device could normally search for NB signals and connect to our background through MQTT protocol. After the device uploaded data...
NRF52840, S140, SDK 14.2
I am trying to write to an SD Card. But whenever I insert the card, I get a failure on ASSERT. I believe this is because I am using P0.0 as the...
Hi Nordic,
I understand that there's a way to monitor the RSSI of a Bluetooth connection using appropriate API from softdevice library. But we are currently developping...
