Hello Team,
Could you please share some sample application or procedure to handle power modes (Sleep, Deep Sleep, etc) of the nrf9160.
Please let me know.
Regards, ...
Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi
I am writing an app to utilise the new LESC feature using Diffie Hellman related pairing. I am testing the app against the Nordic provided ble_app_multirole_lesc. I...
with SDK 10 I found 2 SPI libraries, spi_w5_master and nrf_driv_spi . I hesitate between them.
what' the difference between them? and what should I use when I'm using app_timer...
I saw this tutorial:
nRF51 current consumption guide
It's specifically directed to the nRF51, but I guess the principles of Tuning Advertising parameters must be general...
i'm looking to use only one timer for two independent activities:
battery service (as in Nordic examples) and
a routine to detect a certain button press pattern ...
Hi everybody.
I am makeing a custom circuit for nrf51822 CEAA. This circuit supports ANCS and DFU (nrf sdk 9.0.0). I use only external high frequency (16MHz) oscillator...
Forgive me if there is an obvious answer to this; thanks for your patience.
I'm a long time developer but new to the area of BT in general. After a day or so starting with...
Rudimentary question about DFU; thanks for your patience.
I'm developing an app for a "headless" (no buttons, no led's) ble application which will have a companion mobile...
I am trying to get the pstorage module to work with our application and FreeRTOS. At the moment I keep crashing on port_cmsis::prvTaskExitError().
The pstorage documentation...
Hi,
Nordic Community and Developers,
I am trying to measure current on my custom Development board.....But I found out that it is consuming too much current on the chip...
Hello,
I am writing here because I am trying to change some concrete values from a .hex file in order to vary some BLE and other values. I need this because I need to generate...
Hi,
I am trying to compile & run ANSC example under SDK8 in a PCA10001 board. I have programmed the SoftDevice using nRF Go Studio.
Here is the example,
nRF51_SDK_8.0...
