In the nrf51 series reference manual section 12.1.9 it states that there is hardware protection that prevents write instructions from being executed and that there is more...
Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Dear developers,
We had a working application with SDK11 SD2.0.1 that we have migrated to SDK12 SD3.0.0. With SDK11 we could successfully bond to multiple peripherals and...
Hi. I use the nRF51882 and Arduino ide for developing. My main goal is turn on and off the Led thru the Bluetooth interface. But when I use the UART service for it I have...
I am seemingly haunted by spurious 'soft resets' I cannot seem to find a good explanation.
I have an application that is to be dormant until activated. When waking up I...
Hi, I'm a newbie to Nordic and need to use multiple nRF24LE1s to get ADC values and transmit them to a single nRF24L01 connected to an Arduino. I need sample Keil compiler...
Hi, Nordic
I download SDK13.0.0-1.alpha_055eef3, open project
\gzll\experimental\gzp_dynamic_pairing\device\pca10040\blank\arm5_no_packs\gzll_dynamic_pairing_device_pca10040...
Is there any example of changing the default mtu size of 23 to a bigger value?
We tried increasing the att_mtu to 512, and reserved more ram for the softdevice, but still...
I have a rather unique problem. I want to control an "old-fashioned" DPDT relay using nRF52 GPIO lines. I'm trying to accomplish this task without adding a power transistor...
Hi all,
there is a nice section in here already about enabling the Reset input (P0.21). Unfortunately the link to the relevant infocenter docu is missing.
Could you...
I think that all of the Experimental is all unreliable.
I try it 5 days to test it, It always Failure.
So , I want to know that to how to understand the keyword "Experimental...
Hello developers,
I am struggling badly to use interrupt in my application. I am using softdevice S130 and ble_nus, ble_bas and ble_hrm services. All I want is to trigger...
I would like to update my current bootloader with one, that is bigger than the predefined space of the current bootloader. For that, I want to flash an application via DFU...
currently(sdk_12.1.0_0d23e2a, s132_nrf52_3.0.0_softdevice), nrf52832 can't pairing with windows 10.1607(build 14393.479), if we set lesc bit in ble_gap_sec_params_t.
windows...
Does any one has successed in doing DFU with OpenMesh? I have done all the steps according to the guide ( github.com/.../dfu_quick_start.adoc) but failed in the last step...
