Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi,
I'm using an arduino uno with a readbearlab shield with v1.1 to send sensor data to a android phone.
Using a timer interrupt I try to send data every 0.1 sec (10hz...
Hi all,
I would like to know that is there a method to disable sleep mode in run time and reenable it when I use SD110? You know when the device starts it starts advertising...
I've modified the button press example from nAN-36 using the ADC examples from the git repository.
What I'm trying to do is send the data sampled via the ADC using the...
So I am new to bluetooth smart (bluetooth low energy) and I am still a novice android programmer. I have a nordic nrf52811 evaluation kit and I want to connect it to my android...
I am trying to use Sniffer software on Windows XP. I am trying it with nRF51822 Development Kit dongle (PCA10000). Setup worked fine (nRFgo install, segger install, loading...
I have the following jlink script for flashing an nrf51822
I'm on Mac OSX 10.9 and am talking to the PCA10001 eval board.
r
w4 4001E504 2
w4 4001e50C 1
sleep 1000...
Hello,
I am working on a project based on the nRF51822 with the softdevice S110.
I am trying to develop an application using the main loop provided in an example application...
Hello,
I have been developing and using the nRF9e5 for 7 years and we recently want to try to deploy the device at temperatures of -20oC and below. The code is fixed and...
Hi All,
I am using nRF51822 development kit without the motherboard .
I flashed the ble_app_uart (nrf51822/Board/pca10001/s110/experimental/ble_app_uart) and it was...
Hi,
I've received the nRF51822-Development-Kit, this morning and I can't download any software to the boards.
I've install keil uvision 4.71.2.0, nRFgo Studio and the...
Hi guys,
I plan to buy the development kit from Nordic but I had a couple of questions:
1)I know that in a previous question I posted I was told that I can use the development...
