Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
We are using nRF51822 in our custom board.
nRF51822 is interfaced with a MCU using UART.
We want to load firmware image in MCU which will then flash nRF51822...
Hi,
I have a nRF51822 Development Kit and a nRF51822 Bluetooth Smart Beacon Kit. I want to run on the nRF51822 Smart Beacon Kit the nRF-Sniffer (v1.0.1) application. The...
how i used central send data to peripheral.
one broad use S120and other broad use S110.Now i see explame is nrf51822\Board\nrf6310\s120\experimental\ble_app_hrs_c..have another...
In ble events handler after connecting to peripheral device i handle BLE_GAP_EVT_CONNECTED event and try to identity connected device:
case BLE_GAP_EVT_CONNECTED:
{
...
Use "nrfjprog.exe --eraseall --programs s110_nrf51822_7.0.0_softdevice.hex --program app.hex bootloader.hex --verify --reset" to flash my device, return a error "write_and_verify_hex_file...
Moving from SDK version 5.1 to 6.0, the buttons on my PCA20006 beacons no longer works as expected. When I press a button, it seems to register the release of a button incorrectly...
As I've seen many others have done, I bought the nRF518822 Development Kit not seeing that I needed the $400 nRFgo motherboard.
Searching around reveals that shouldn't...
I am trying to get the Arduino DUE up and running with the Redbear v2 BLE shield, and SDK 0.9.3.
It was a pretty trivial operation with Arduino YUN, but I not so much for...
Hi Nordic-Team,
I've spent a while trying to figure this out but I couldn't. I need your help.
I want to load the S310 softdevice to the nRF51422 chip + the blinky example...
Hi,
I am using the ANCS experimental library and am experiencing a very strange bug.
I am requesting to attributes: APP ID and Title whenever I get a notification source...
Hello,
i have some trubble with my current power consumption. I have already read other user question and solutions but nothing works for me. To reduce the power consumption...
I have built and installed bluez 5.21 on ubuntu 14.04 witout problem (see for example this recipe ).
My nrf51822 EK dongle PC10000 is not recognized by hcitool:
hcitool...
What exactly is block size in pstorage?
Desired block size for persistent memory storage, for example, if a module has a table with 10 entries, each entry is size 64...
