Hi, I am running openthread on the NRF54l15 DK. Whenever I am debugging and hit the breakpoint or pause the program, then on resumption my app crashes. How Can I debug while...
Hi everyone,
I'm working on a project using the Nordic nRF5340 microcontroller and I need to count both rising and falling edges of a square wave signal on pin P0. 14, coming...
Hello, I’m working with a combination of nRF5340 + nRF7002 + NPM1300 , and I’ve only changed the I2C pins connected to the NPM1300 to sda pgio1.4 and scl gpio1.6 .
SDK...
I am running into a secure fault when I set the NVS_SECTOR_COUNT to >= 7, not sure how to proceed.
it fails at nvs_mount(&fs)
I have added a nvs_storage partitation...
I've seen other threads about the issue:
- https://devzone.nordicsemi.com/f/nordic-q-a/117267/light-bulb-sample-works-on-nrf52840dk-and-doesn-t-on-nrf52840-dongle
- https...
Here is my script for programming. Does the sequence is OK? or any advice to improve?
nrfjprog --eraseall
nrfjprog --recover --family NRF53 --coprocessor CP_APPLICATION...
Using the peripheral_uart example routine from the NCSv3.0 library with the 54l15 chip.
1. compilation command： west build --build-dir build . --pristine --board nrf54l15dk...
Hi,
I'm looking for a wireless solution to handle 500-1000 of Clients per area. Because i',m new to Bluetooth i don't know if this is possible.
Requirements:
Network...
Hi,
I using the application download the update firmware, and using the bootloader erase and write the firmware to flash.
And I changed the bootloader code, remove all...
Dear Nordic Developer,
I am using nRF51822 with softdevice.
What is the best approach to have a nRF51822 always discoverable? Like heart monitor for example : no need...
If I receive data on the UART that comes in via its event handler, how can I then create an event to wake up from sd_app_event_wait and do further processing from the application...
400 control modules
I'm starting a project.
I need to reach a maximum of 200 meters.
I work with PIC. I'll have to control 400 MODULE Transceive.
Which model should...
Hi,
I have modified the ble_app_hrs source code with more no of custom characteristics(approximately 10), When i press Service Discovery in the master control panel, i am...
Hi ,
For our application i created 9 rtc1 timer .
all timers are working fine.
but once i stop battery timer and start it again ,it is giving receiver link loss....
Hi,
Actually In our application we have a battery, by external source we can charge it. Now when we connect battery or external power supply directly no error is coming....
hello!
ANT protocol;
have three nrf51922 , A can find B, B can find C. but A can't find C. A. how to communicate with C by B ? And C how to return a reply?
I want to know...
Hi ,
i am using ppi channel 0 for i2c1 bus (Accelerometer).
and also i am using ppi channel 0 for i2c0 bus (LED controller).
But both are working. but some times...
I took the ble_app_proximity as an example.
Before I introduced the scheduler it worked ( not always but reasonably well).
I added APP_SCHED_INIT(SCHED_MAX_EVENT_DATA_SIZE...
