Hello Team,
I am currently using the nRF54L15 DK with NCS version 2.9.0 for development and compiling code for the nRF54L10 board.
I am trying to implement FOTA updates...
Hi As part of attempting to write code for self testing I'm trying to measure the HFXO frequency using the LFRC (we don have an LFXO) I'm expecting that the measured HFXO...
Hi,
We're planning to design a custom board using the nRF9151 for LTE connectivity. We'd like to add basic BLE support, with the following constraints:
The BLE chip...
Hi,
I am trying to set up a project that continuously measures the pulse width of a signal that may or may not be present at a pin.
I want to use a Timer in capture...
hi
after success dfu operation the firmware start to run
then i am getting stuck write after err_code = sd_ble_gap_device_name_set(&sec_mode, new_name, DYNAMIC_NAME_LEN...
I've been following the information on the nRF54H20 with interest as it is most likely the natural candidate for upgrading our existing design. However, I have been waiting...
We are developing an application on nrf52840 and wanted to use M95P32 as external flash.
used below .overlay configuration to enable it on zephyr.
&mx25r64 {
compatible...
Hi,
I'm using S130 with PCA10028 and I would like to connect my central device to multiple peripheral at the same time.
According to my understanding, the only way I...
Hello everybody,
we want to extend out Central device to dual role (Central + Peripheral). I just finished the migration to SoftDevice S130 and was about to migrate the...
Are there any laws or regulatory certifications that state a wireless or Bluetooth device must be able to power off or at least stop transmitting through user action? Can...
My project is compiling and working, but there is this very annoying issue when Keil thinks there is a problem with __STATIC_INLINE in the file cmsis_armcc.h.
It indicates...
I can see in nRFgo Studio that I can set a custom advertisement type/value to be included in the advertising packet. I would like to modify this data at runtime. I see plenty...
Hello all, before I decided to write my own question I read the forum thoroughly. How ever no aid found to solve my problem.
At first I want to make "just work" bonding(pairing...
Hi, we are currently using the nrf51822 for sensor communication.
Is there a possibility to make it airplane ready? Which means, no rf emmision for the ble for some unknown...
Hi,
I'm trying to interface the nRF8001 using an MSP430 device (specifically Adafruit's breakout board and MSP430fg439) for sending analogue data from the sensor hosted...
Hello all,
(I'm 99.99% sure the answer is "yes", but I've been asked to find out for sure, so...)
Can the (S310) SoftDevice be updated via a bootloader, on an nRF51...
i set the service uuid as 0x0 and after i debug the program, i can't find my device. i don't know how to solve the problem. maybe i should not use 0x0?
thanks for you help...
I am using Bluefruit BLE sniffer based on nRF51822 chip. Now Wireshark seems to decode most of the messages but not those where the actual information is being transmitted...
I was trying to develop a project using nrf51822. Which needs to send data over ble and do some functions according to the data received. In which I have to add a lengthy...
