Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello Everyone,
I was taking a look at the PCB in Ditto . It uses an nRF51822 and supports firmware updates from their app which means they put a bootloader on it.
I've...
hello guys,
I'm working in a project & I'm debugging using nrf15822a development kit, I want to implement the DFU & security feature to have a secured link and to be able...
Hi guys..
I try to figure out how to connect nrf 51df , raspberry pi (ble enabled router), COAP client which is on the external network. Trying to figure out it, I found...
I noticed the following compile time issue in the SDK - both 10 and 11:
The file ./examples/ble_central/ble_app_hrs_c/main.c
needs:
#include "app_uart.h"
For...
Hi,
Could anyone give some advice how can I let 51822 works in RFID mode.
Can RFID work together with BLE? Or is there anoter HAL support like Softdevice? Where can...
Interrupt_Sleep.txt
Currently, I'm trying to use external interrupt that generated by ADXL345 to wake up the nrf51822 after sleep but not working as i want. Kindly check...
I'm had develloped some software and tested it on the nRF51-DK.
After that I made my own PCB design where only the nRF51422 is replaced by a nRF51822.
When I flash both...
I have a legacy RN42 BT2.1+EDR running in a system as the network master that I need to connect/pair with a nRF51422 BLE dev kit, and am having problems.
The BLE just doesn...
HI All,
I tried to migrate from nRF51_SDK_10.0.0_dc26b5e to nRF5_SDK_11.0.0-2.alpha_bc3f6a0
my migrated ble_stack_init:
static void ble_stack_init(void)
{
uint32_t...
I will try to use the s110 8.0.0
But I can not find the sdk installer from the website.
Three months ago, when I visited the website, there is a SDK 6.xx.xx Installer...
Hi.
I'm currently receiving advertisement packet from beacon scanner app. (nrf51822)
(ble_peripheral/experimental_ble_app_multiactivity_beacon/hrs_scanner)
I tried...
