Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Hello,
I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
Hi,
i tried to send data from ios 7 via tx_characteristics(like in UART example) but received error:
didWriteValueForCharacteristic 2A38 error = Error Domain=CBErrorDomain...
I have been trying for a few days now to get my environment setup for development with the nRF51822. Since there is no official configuration for the Mac w/ Eclipse I have...
Apologies if this has been asked before but did search for 'format' in faq and got nothing.
I have been answering to questions.
In my answer I place hard empty lines....
Hi
i use nrf51822 s110 "hrs" example to transmit the data to ios.
I need to add an option to send back some data (from ios to nrf51822). 10 bytes maximum .
how can i implement...
Hi
i use the hrs example to transmit the data to ios.
but i need to add an option to send back data (from ios to nrf51822). 10 bytes maximum .
how can i implement...
The below source is mine.
ble_app_beacon.zip
I know that it is possible to display the information in the manufacturer data or service data.
I chose which manufacturer...
Hello, I'm working with the EK PCA10003, that has the NRF51422. I'm trying to read the information of the accelerometer MPU6000 with an ISP interface. At the moment I cannot...
I'd like to use the GATT/GAP driver from an ARM based Linux system. Is there any possibility of getting a library compiled for ARM or (cough) the source code to build it myself...
I am trying to write my firmware in mbed instead of microvision. I have my own custom PCB w/ the nRF51822 and use SPI with different GPIO pins than the standard ones.
My...
On the following code I have a packet of 6 bytes that I write to a buffer. I pass the buffer as read_packet function argument. When optimized, the code doesn't work. I only...
It is possible to run easily a SoftDevice stack (e.g. S110) on nRF51422 using an accurate 16MHz external clock reference for HFCLK instead of an external 16 MHz crystal oscillator...
hi, nordic staff.
i'm working with s120 v1.0.0. and i recognize that the transmission and receive buffer is only one for every connection(up to 8 simultaneous connection...
First, I flash the softdevice, then I flash the bootloader, then I use a smartphone app to upload an application to the device via BLE.
but, The first operation only. When...
Hello Nordics.
I developed a device that display a navigation information using s110 (nRF51822)
My device receive the road information by an application.
But, when...
Hi,
I'd like to get a timer with 1ms interval or higher resolution, and found some questions about this:
If the app_timer is used, looks like we only can get minimum...
Hello Everyone,
Scenario is i am getting some commands from Master(Android based Mobile App) to start some function , After i get the commands i disconnect from master...
Hello,
I tried firmware over the air update with mbed using the compiled bootloader hex file and it works pretty well.
However, I am back to GCC with softdevice 7.1...
