Help Needed: BLE Not Working on nRF52810 (Tried Zephyr & nRF5 SDK)
Hi everyone, I really need help getting BLE working on my custom board with the nRF52810 . I've been trying...
Hello everyone,
I'm reaching out to this forum in a bit of a bind and hoping someone might be able to offer some guidance or assistance.
I'm trying to download the S340...
Hello LE-Audio team,
By any chance, do you have a working code base that supports a headset with 2 end points instead of just one as your sample nRF5340_Audio kit?
If...
Hi, I just tried to connect LSM6DSV IMU with nRF52840dk
The whole folder structure is shown below :
1. I set nrf52840dk_nrf52840.overlay file first.
2. I...
Hello,
We are designing a new Zigbee/Thread end-device sensor and I'm wondering what is the recommended part for it.
I have a demo running with nRF5340 (because the platform...
Hi Nordic team,
I'm using the nPM2100 PMIC in my design to power a microcontroller. The microcontroller sets the nPM2100 into Hibernate mode , and a vibration sensor connected...
Hello,
We are currently using the nrf52840 for development using Zephyr v3.7.99-ncs1 .
We want to use the UART in low power mode and therefore, we have used the zephyr...
Hello all
I'm struggling with link errors, "undefined referencce atan2" as well as all math library.
I still dont know why it is occurred these errors.
I configured the...
Hi,
I'm trying to move my code from Red Bear BLE shield with Arduino to nRF51 dongle.
Is there any possible method?
(ex. share the same library or SDK helping)
I just read the S13x migration guide .. have some work to do :(. I'll have to read it a few more times to get my head around the bandwidth configuration but it looks super...
Hello, I started with NRF24L01 + Arduino and that works fine for me. Then I saw the nrf24LE1 and I thought that would be smaller and cheaper. I ordered the NRF24LE1 development...
Hello Everyone,
I was taking a look at the PCB in Ditto . It uses an nRF51822 and supports firmware updates from their app which means they put a bootloader on it.
I've...
hello guys,
I'm working in a project & I'm debugging using nrf15822a development kit, I want to implement the DFU & security feature to have a secured link and to be able...
Hi guys..
I try to figure out how to connect nrf 51df , raspberry pi (ble enabled router), COAP client which is on the external network. Trying to figure out it, I found...
I noticed the following compile time issue in the SDK - both 10 and 11:
The file ./examples/ble_central/ble_app_hrs_c/main.c
needs:
#include "app_uart.h"
For...
Hi,
Could anyone give some advice how can I let 51822 works in RFID mode.
Can RFID work together with BLE? Or is there anoter HAL support like Softdevice? Where can...
Interrupt_Sleep.txt
Currently, I'm trying to use external interrupt that generated by ADXL345 to wake up the nrf51822 after sleep but not working as i want. Kindly check...
I'm had develloped some software and tested it on the nRF51-DK.
After that I made my own PCB design where only the nRF51422 is replaced by a nRF51822.
When I flash both...
