Hi,
I am trying to perform a DFU using SMP over BLE. My setup has NSIB and MCUBoot enabled and thus I am able to perform DFU for MCUboot and Application using nrf device...
Hi all,
I'm trying to use uart2 on my custom nrf9151 board, but I'm stuck. As I understand, I use i2c1 so I can't use uart1 and i2c1in parallel, so here is why I wnt to...
Hi - I am seeking clarification on a topic as I am a little unsure on the correct way to do things.
I'm using an nRF52840 and porting an old Firmware from nRF5 SDK to NCS...
Hello,
I'm moving my project from SDK1.9.1 to SDK3.0.2. Project is based on peripheral_uart sample (UART part is removed since it is not necessary).
I have encountered...
Hi, i'm using NRF5191 with DECT.
DECT modem: 1.0.2
App: hello_dect sample
In datasheet I found that NRF9151 support various band: 1,2,4,9,22
and I'm using these value...
Hi there,
on the nRF5340 Audio DK, there is a FT2232H, which provides FTDI_SPI + FTDI_SPI_SEL.
How this can be used, is there any sample for this available?
And how...
Hi
I have some questions about nRF5340 & nPM1300 decoupling cap
nRF5340
1.For pin A3/D2/H11/K1/L5/L11, ref. SCH is 1uF*1 and 0.1uF*5, could we only connect 1uF*1 and...
Hi ; Following my question how-to-flash-with-jlink-command-line which was successful, I can flash Soft Device and my app on my nRF51822 board (mac os x + gcc)
Now I would...
I am trying to set the transmit power of the NRF51822 (e.g., on the PCA10000, v.2.0.0, but the same happens on other nrf51-devices). I am not using any softdevice.
I use...
Hi
I've updated our platform to using the S130 2.0.0-7 Alpha (Update1). It turned out, that the initialization in out application failed, because erasing a flash page never...
Hi,
I am trying to set up an SPI communication between nordic nrf52 (as a master) and another slave peripheral. I'm using nrf52 sdks 0.9.2. I tried spi master loopback...
I am developing a new BLE product with only peripheral role. In the SDK11 the SoftDevice 110 is no longer supported.
What are the pro and cons to still use the S110 with...
Hi,
I have a question but may be it is not you to ask from. I need to communicate my ble device with iOS phone. How to re-establish link and restart my ios app if it was...
How long should it take for connection to to re-establish after two devices have been bounded? In my case it takes 5 - 10s no matter whether central and peripheral are already...
Hi,
I got a question on power consumption:
In my case, I do not need RF functions on most of time. If disable RF function, what working current of nRF51822 would be? ...
when phone connect to the device, I print the connected address.
However, I find that the bluetooth address is not same with the phone bluetooth address.
here is the debug...
Hi,
I am trying to include temperature (read from DS18B20) in advertisement data using BLE_UUID_HEALTH_THERMOMETER_SERVICE. So far it works fine, but my temperature is...
Hey,
I am using twi_hw_master.c and twi_master.h libraries for twi and want to disable i2c to save power when not in use.
I use the following two lines to disable the i2c...
