But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi Support Team,
one error come out when use nrf connect, just as attached picture shows,
please help to check what cause this error,
no error come out on phone.
...
In reference to this issue in the Android DFU library...
github.com/.../33
... can someone from Nordic please explain how DFU OTA using the secure format on a device...
Hi,
I working on nRF52 series development boards communication. I am using ESB library for data transfer. I am able to transfer the data between two microcontrollers. Now...
My device is connected with GSM module, when GSM module communication fail, I need to save the error message to flash. In application level, pstorage_store or pstorage_update...
Hi,
I use fstorage fun in nRF5_SDK_12.1.0_0d23e2a.
and the same code can run SDK11 but It seems different now.
So how to use fstorage fun in SDK12 and I list the different...
I was looking for something like a checklist of what to do when developing on a custom board but I couldn't find it.
I am working with Keil 5.15.
I achieved to develop...
Hello, i have a question.
Can nRF51822(s120) handle more than one connection at same time?
Let me explain: i have one server(nRF51), and two(or more) clients(nRF51 and mobile...
My Chip is a Insight SIP ISP1302.
It's based on a 51822_xxAB, 128kb Flash and 16kb RAM.
I try to use the S130 with the UART Application.
The S130 2.0.1 requiers 108kb...
Hi,
NRF_LOG_PRINTF() is working fine with peripheral examples in SDK11. but when I try to do the same in ble_peripheral examples it is not working. I have defined the following...
Hi. I have one question:
From SDK and docs, I can find how many pipes and which pipe nRF24LU1 open when it is TX.
I check function:
void hal_nrf_open_pipe(hal_nrf_address_t...
HI:
i hava a sender and it send a frame every 15ms ,not use any protocol,and reciver code like as follow:
while (1) {
Rf_StartRx(ReciverSC.RfBufPointer...
Hi,
I am trying to develop firmware for the nRF52 platform using Visual Studio, as I prefer VS over Keil. I came across the VisualGDB plugin, but it seems their BSP is...
