What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
Hi
I have a question about using gazell link layer and paring library with concurrent timeslot api. I try to do this but i have the hard fault handler after invoked nrf_gzll_init...
HI,
I want to use PWM to control various hardware (LED's, etc ..) so I started off from the suggested PWM code example, found in this forum + modified it as I want to use...
Hi Nordic/Zephyr Community, observer behavior:
-- west build: generating a build system LIBRARY_SDK_BASE:= C:\cm\projects\zorbit\library_sdk ZEPHYR_BASE:= c:\cm\ncs\v2.1...
I'm testing out my new PCA10040 dev board. I can see the board in Windows Explorer when it's connected and I can see the two preloaded files as in the attached screen shot...
Hello Community / Nordic How can I have a boolean property in my mp2723 device driver devicetree dts or overlay. I am using NCS v2.2.0 in MS Windows 11 with VSCode 1.17.2...
Hello!
Using nrf_gpio.h enables P0.00 port control, but using app_timer.h together makes port control impossible.
I don't know if the code I wrote is the problem or...
I am using zephyr 3.1.0 and i build blinky pwm and rtc code from zephyr but it is not building i am using nucleo_u575zi_q board but in dts of board pwm and rtc is not there...
I modified the nrf9160 https_client sample to make a GET request to a web server and retrieve a JSON response. Unfortunately the rec_buf always ends up with an HTML response...
Hello everyone!
I've been struggling to get over this error when attempting to use an augmented Thread project based on the thread_mqtt_sn_client_publisher example. Would...
According the nordic documentation of the AT command +CEINFO, the value of CINR is in dBm.
Other source (outside Nordic) mention dB as common unit, e.g. LTE signal quality...
Hello everyone,
I'm trying to display internal sensor on NRF51422-DK (PCA10028) on my Android phone (v.12). I'm using Keil for programming and nRF Toolbox to see UART results...
ble_gap_addr_t xyz;
sd_ble_gap_addr_get(&xyz);
/**@brief Get local Bluetooth identity address. * * @note This will always return the identity address irrespective of the...
Hello, I have three questions that i could not clarify in an adequate amount of time via Google and DevZone.
Setup: I am working on a custom board equipped with nRF52805...
Good day
I am trying to use lwm2m_engine_set_float on the lwm2m_client sample to change the sensor value.
Referring to the above link, the sensor value is set in the...
I am trying to evaluate transitioning a product from the NRF52840 to the NRF5340, but we have a critical feature that uses specific functionality of the PPI. It seems that...
Trying to integrate memfault SDK to nRF SDK 17 segger embedded studio. But couldn't understand the below section. Can someone help with passing flags to linker and also adding...
