Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hi,
We have an existing nRF91 (nRF9151) project (NCS 2.9.0 ) that already includes multiple modules such as ECG, external flash, RTC, modem, etc. Now we want to integrate...
Hi Team,
I would like to interface the nrf9160 with nrf7001 by using the SPI. While building the WIFI-Scan example by using SDK 3.1.1. Even by using WIFI-shell example these...
Hi team,
I am experiencing a persistent MPSL assertion 1519 on nRF54L15 that occurs consistently at ~5 seconds after BLE advertising starts. The assertion indicates that...
Hi everyone,
I’m using nRF9151 with nRF Connect SDK 2.9.0. Without changing anything in overlay, prj.conf, or source code, several of my projects suddenly started failing...
Hi Nordic DevZone,
We recently acquired some Pro Micro nRF52840 Dev Boards ( link ) and were looking to use them with the nRF Connect SDK. The boards use a UF2 bootloader...
I have a question about the nRF54L15.
１．I would like to know the maximum number of devices that can be registered for whitelist and bonding.
２．I want to know how to...
I am having an issue where my nRF52840 Development Kit is not being detected by nRF Connect for Desktop , specifically in the Quick Start and Programmer apps. The DK does...
Hi, I have an Adafruit Feather nRF52840 which I'm programming using SDK 3.1.1. I want the following UART config but it is being rejected with error -134 which I believe means...
Here is a professional and technically detailed ticket template you can use to submit to Nordic Semiconductor (DevZone) , Quectel Support , or your internal System Architect...
Dear Nordic,
Could you please guide us how to set HCI_LE_Transmitter_Test / HCI_LE_Receiver_Test command?
Do we have to use Test mode command too?
Thanks.
When using the official Au Term.exe tool to perform SMP firmware updates on the nRF54L15 (NCS v3.1.0), if the tool is closed during an ongoing transfer and then reopened,...
Hello,
I previously completed a project using the nRF24LE1 chip and the nRF24LE1_24_SDK library. It was a simple 2.4 GHz two-way communication system using the basic predefined...
Hello
I am currently working with the nRF9151-DK hardware to perform tests related to PSM functionality on an NB-IoT network.
The main issue is that, although the device...
HI,
We are using the IM69D120 PDM mic for our audio application. I am able to interface the MIC and record audio with the NRF5340.
I have read the PDM data and stored...
