Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hi, I am developing using nrf52832 and st7735s.
Successfully displayed the lcd screen using the code in \examples\peripheral\gfx
However, when screen clear, text_8print...
Dear friend I checked the data sheet of 52820 and I didn't see any LPCOMP peripherals. Check the data sheet of 52832, there are LPCOMP peripherals. Comparing COMP and LPCOMP...
Hello,
we would like to use a pin on GPIO P1 as GPIO in non-secure mode, but only found the solution stated in this thread yet: https://devzone.nordicsemi.com/f/nordic-q...
Hello,
I am experiencing issues with an nRF5340 board and its SPI.
I am trying to add an Pmod OLED (128x32) screen to my board, but firstly I am trying to set up the...
Zephyr nRF52840
I am working with 2 nRF52840dk. The master side seems to be working as expected. i have monitored it and seen clock, MOSI and CS all working as expected...
Hello,
I have a debugging issue with VS code IDE.
Suddenly, i cant debug with an error:
However, flashing board is working succesfully.
What am i supposed to do...
We use spi flash with custom driver and goal is to set it to act as secondary partition for MCUBoot.
The question is how to adapt driver to be accepted by MCUBoot, maybe...
Hello,
First off, thank you for reading this. I know this is on the cutting edge, so bugs are to be expected.
Problem:
I loaded the dm sample found here: https://developer...
Hi,
I am using nCS and mcuboot in my application for development, on nRF52833.
I build a nCS project, the build bin file (prj.conf as ):
I broke up into packets...
Hi. I am trying to use Free RTOS in my code and from the example blinky free rtos I am recreating the code. I have added the path and library files. But when I try to compile...
Hi All,
I was trying to upload the latest revision of some code i wish to verify before pushing to production and was using the command line to generate the bootloader...
I have a simple blinky application. I was able to get the application running and using the Qzone debugger. When I change the application te be a MCUboot compatible application...
Hello,
I just noticed something odd. When I just the hex file have provided with me
It worked perfectly, however, when I try to flash the lte_ble_gateway sample program...
Hi Nordic Support,
I'm getting this error while trying to connect two 52840 DK, one programmed with the connectivity firmware, and the other one with a sort of ble cli...
HI,
Following is the procedure to flash application we have tried:
Mass Erase
Write bootloader start address
Flash soft device
Flash bootloader
Flash application...
