Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello all
I am playing around with the nrf52dk for the last 14days, done some progress, namely the TWI is working and I can read the sensor and printing its values in the...
Hi
I have a strange issue here.
I have been working with Nordic's sample project for AWS IoT, with the nRF9160DK.
What I usually do to see the serial output, is to view...
Yesterday, I tried to connect to my nRF5340's serial port in vscode by calling "nRF Terminal: Start terminal" from the command palette. Unfortunately, the response I received...
hello,
TCA9548A is the i2c multiplexer I am using. The problem statement is as follows:
The I2C multiplexer is connected to nRF52832 via twi communication. I2C multiplexer...
Hello,
I just saw the App update on google play store with below changelog :
Mesh library adds support for Timezone messages and generic global location messages.
But...
The project I work on is considering updating from SDK version 1.71 to 1.9.0 to benefit from some updates. (Thanks!)
As I was looking over the Known Issues I noticed KRKNWK...
Hi
I am testing the new distance estimation techniques introduced in nRF Connect 1.9.0.
I have flashed both of my nRF52833 DK kits with the sample code connected to this...
Hi,
this is something of a follow on question from https://devzone.nordicsemi.com/f/nordic-q-a/85892/basic-gpio-on-nrf52840-development-kit
I'm working with NRF Connect...
Hello everyone,
I am working on an application where I am using the BLE Nordic UART service (NUS) with a changed service UUID. I need to be able to uninitialize the service...
Dear ,
I am using nrf52833dk with NCS1.7.0 SDK.
Is there any flag or register value that I could use to determine if the device has been connected via USB? Or I can only...
I working on Asset_tracker_v2. I found in the project :
target_sources_ifdef(CONFIG_CLOUD_MODULE app PRIVATE ${CMAKE_CURRENT_SOURCE_DIR}/cloud_module.c)
in file at
C...
Hello!
I was just wondering if it is possible to use multiple encoders at once with the QDEC driver? Can you initialize multiple encoders on different pins or do you have...
Hi,
I use self bord with nrf5340 on it.
i started with project "central_and_peripheral_hr" and added CMSIS v2 and EVENT MANAGER configuration.
The i configured interrupt...
Hi,
I am using the nrfx GPIOTE driver to manage the output, input and interrupt on a nRF5340 on top of Zephyr Framework.
I know I can use the GPIO Api from Zephyr, but...
