Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi,
can we change duty of one channel of an instance of modules\nrfx\drivers\src\nrfx_pwm.c without affecting or introducing any glitches to other channels of that instance...
I am trying to get an SD card working with the NRF52832 chip, starting with the sd card example (SDK 14.2) using the fatfs module.
The SD card I am using is a Kingston 8GB...
Hi I'm using nrf52DK board with SDK 14.02. I wanted to use PWM Library with softdeivce but I'm getting this <error> app: ERROR 3735928559 [Unknown error code] at E:\nRF5_SDK_14...
I have a Raytac module which contains a nrf52810 AT module in it hooked up to a micro via Uart, so i can send and receive AT commands and data. I'm trying to connect to my...
Hi, I have developed one custom application and enabled DFU features in it.
With the help of nRF Toolbox mobile application, I am changing the application code.
Now I...
I just installed the nRF9160 DK but it showed yellow exclamation marks at the CDC and BULK interfaces. I'm using Windows 7. I couldn't find where these drivers are.
Anyone...
How do I use PWM on a GPIO on port 1 on SDK 15.2? The PWM library examples only sends in the pin number and seems to assume port 0. This answer seemed a bit complex and I...
Dear all,
I modified the example "ble_app_uart" based nRF5_SDK_15.2.0_9412b96 and S132 SoftDevice v6.1.0 to do some tests . But now I encounter the disconnect reason 0x22...
Hi guys, help me please.....
I want to build a device act like both keyboards and mouse. I've made some progress that the device can connect to my PC(win10) successfully...
Hi all
I developed my custom NRF52840 pcb followed by nordic design..i have done program flashing.Blinky LED also working.But Beacon advertising is not working.while flashing...
Dear Sir
I was working with nrf52832.
.SDK version ------------- 'nRF5_SDK_15.0.0_a53641a'
Soft device - s132_nrf52_6.0.0_softdevice.hex
I was handling a scenario...
I measured the consumption of nrf52832, in deep sleep mode, the consumption is 32uA, the question is: there is a pulse about 5mA every 39ms, is that all right? what's the...
