Hi Team,
To implement iBeacon what are the things to be take care at the peripheral side.
Whether the code for advertising the peripheral in "CoreBluetooth" and "CoreLocation...
Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I want to add a custom at command in the SLM example . I follow the https://developer.nordicsemi.com/nRF_Connect_SDK/doc/2.6.1/nrf/libraries/modem/at_cmd_custom.html , enable...
Hi.
I have a problem.
I changed project settings 52832 -> 52840
on 52832 the project work perfectly.
using 52832, SDK 15.3.0 S332, ble, ant, ble dfu.
now I wanna...
I use one channel of the SAADC on nRF52832 to measure the power supply voltage. Code for configuration & operation of SAADC attached:
Short description:
- Configure...
Hello and thank you for your time. I seem to be getting some incorrect performance from the flash memory with NVS, in that NVS needs to be primed or something before it works...
Hi,
I'm working on a board that uses an npm1100 (QFN) in the following configuration:
When testing my board, I populated it with only the components shown in the...
Debugging my application indicates that I might be not servicing BLE NUS RX frequently enough bt_nus_cb.received is sometimes not called timely Is there any way for user to...
Hello all,
I'm using a custom nrf52840 dongle. There are some questions about bootloader and Softdevice. Everything works fine when I use nrf Bluetooth Low Energy app...
Hello.
I have a product that I am working on which a peripheral and it is able to communicate test data over BLE UART connection. For development purposes, we have internally...
Hi Team,
I have 1 nRF5340 Audio DK. With the steps mentioned in below links, I configured Json file to Gateway and I'm able to achieve it. ( developer.nordicsemi.com/.....
Hi,
We are developing on a nRF52832 MCU and we tried to enable MPU on the whole RAM region (addr: 0x20000000, size : 0x10000) But when we create a new MPU region around...
Hi,
So I have seen there is a clean -up option to set the architecture core HW registers to their warm -reset values as specified by the architecture before running the...
Hello everyone,
using Segger Embedded Studio, I encountered an issue with the TWI libraries. My device consists of a custom PCB controlled by the nRF52840 (programmed with...
A simple and maybe trivial question. When in a thread I wait data for example with
is it like call continuously the k_yield()? How the api above works in the underhood...
Hi
is there any example or Tutorial to start from the beginning stage of developing Multiprotocol (BLE and Thread)?
I've tried searching many articles still unable to...
