Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hello,
I am trying to measure the current of the dk. I added the 10o resistor, loaded the ble blinky example and connected two probes. This is what i got:
In the idle...
Hi Nordic,
we started with the light_switch example
and created a second onoff model to it -> system compiles but runs into error
also tried adding a other generic model...
Hi All.
In custom report descriptor I try to use this code:
ret_code is NRF_SUCCESS
but on host while reading feature report I don't se a changed value. Maybe I'm...
Hi,
If an ESB PRX has queued a 250-byte auto-ack payload, that will take around 2ms at 1Mbs to transmit.
If the ESB PTX has the standard 250us repeat interval, will the...
I am confused about the value of RX_PW_Px register what will be the value of this register if more than 1 dynamic payload packet arrives on the same pipe-x.
I'm a beginner I'm having hard time understanding UART. In my opinion, the documentation is going too straight to the technical details and tutorials without even starting...
Dear friends,
Is there any ideas for measuring the distance between a BLE module and a beacon module without using RSSI?
With Regards,
Sunil
Calixto Systems
hi..........
i have developed nRF52832 QFAA using your schematics,and i have added sensor to it . Now i can able to flash the code and ran successful but i can't able to...
Hi,
We are developping a system connected to several devices based on NR52 MCU.
The DFU works with the nRF connect application.
Now, we would like to update the device...
Hi,
I am just getting started with the thingy 52 and I need some guidance. I am a EE by profession so I feel a bit out of my league here.
When I unwrapped my thingy I...
Hi there,
I am adding security to my service characteristic and i found that for security mode 1 level 4, bonding is required in order to access characteristic values. Is...
Hello,
My problem is pretty much identical to this one:
devzone.nordicsemi.com/.../
My functions look exactly like the ones posted in the original question and I...
Hello, and thanks for all the great examples!
I've gotten the COAP transport for background DFU working on my custom hardware platform and app, however I have noticed that...
Hi,
I do have a NRF51-DK and want to use it as a external programmer. I connected it to the OUTPUT Port which worked fine, then I flashed the mbed firmware on it because...
