Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi,
I’m trying to understand the bigger picture related to BLE Audio in order to create a simple wildlife monitoring project. The hardware I’m thinking about is a nRF5340...
In the release notes for mfw_nrf9160_1.3.2 it says "This release is aligned with v2.1 of nRF91 AT command reference guide." And new functionality: "- Feature to output GNSS...
Hello, Nordicsemi community,
I am a bit confused about how I need to proceed in order to use both cores in my nRF5340 that lives in a custom board.
I was playing with...
Hi,
We are developing a product with an nRF528322 that should be able to perform a DFU on an external microcontroller by receiving the firmware over BLE and then sending...
Hello,
i'm using nRF5 SDK 17.0.2and nRF5 SDK for Mesh v5.0.0 using the examples sensor client and server.
I am trying to create a function that makes the client client...
Hello,
is it possible to see periodic advertisement packets (AUX_SYNC_IND and AUX_CHAIN_IND) when sniffing the normal periodic_adv sample (running on 52840DK) with a 52840...
Hi all.
I have a problem when employing QRS peak detection library on github to my NRF52840 board.
i just add the PanTompkin.c and PanTompkin.h into my project without...
I'm just redesigning a circuit using the nRF9160 and wanted a second opinion on this.
I am no longer using the GPS antenna on this chip, and I want to make sure this antenna...
I am in the process of migrating a project using the nrf5340 from nRF Connect SDK v1.6.0 to v2.2.0 .
I have run into an issue where gpio pins I could use before are no longer...
Hi There.
I'm using the Asset Trackerv2 as a base for my application.
If I provision certificates at boot pior to enabling the LTE connection. the GNSS is never enabled...
Hi,
I'm trying to develop an application that uses an nrf52840-dk board and the pc-ble-driver-py. The dk is supposed to be a central device.
Using the python driver library...
1 I didn't understand ANT on nRF5340 under Highlights. I didn't find the introduction I thought of in the following article.
2 Added the CONFIG_ESB_DYNAMIC_INTERRUPTS Kconfig...
Hi all,
I have recently moved to the last nRF Connect SDK version. As of now, I am using VSCode as IDE. Unfortunatly I can not find a way to specify the flash runner when...
hi dev
I have a question about energy harvest over BLE beacon.
As you can see from previous tickets, I'm working on making beacons using energy harvesting.
And now I...
