Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
I am using the Sparkfun thing plus nrf9160 feather with SDK 2.0.0 and modem firmware 1.3.2. Ultimately I would like to get LTE working along with GNSS, however, I can't even...
Good morning.
I am looking for an example of how to program the u-blox NINA-B221 module using the AT commands so that it is compatible with the application of the Nordic...
I've just updated from nRF Connect v1.9.1 to V2.0.0. In my bluetooth code that worked in the older version, I setup a couple of callbacks for BLE pairing:
In v2.0.0, I...
Hi, We are developing with the nrf9160dk as our development board. We are working from the aws-nrf-cloud a-gps sample (cat tracker sample) for our stack as our main system...
I'm trying to work out why this happens, but am not a great expert at linker scripts. Currently, we use arm-none-eabi to build our projects (and cmake) to great effect. I...
Hello,
we are using the following equipment:
- nrf5340-DK Board
-Zephyr SDK 1.9.0
Our application is intended to transfer a large number of data over BLE.
So, we...
I would like to test nRF52832 passkey method with pc-ble-driver-py ( https://github.com/NordicSemiconductor/pc-ble-driver-py) . Does pc-ble-driver-py supports passkey? Where...
Hi, I am developing an application that includes the following features: 1. PWM to control the buzzer 2. 2 Uarte to communicate with 2 external devices 3. BLE to wireless...
I am trying to speed up the burning process.
I am using JLink ULTRA+ (swd max speed 50Mhz) and Jlink base( swd max speed 30Mhz) and NRF52833 but still get almost the same...
Hello,
We developed a system that consists of 1 central and 10 peripherals, all are based on nRF52840. Below is the configuration of the system:
Central: AWSFreeRTOS...
So I've been reading and re-reading all the guides and white papers for the last week, and I think I almost have my head wrapped around everything, but am struggling with...
I have a code build on top of nrfx 2.0 and after a few received bytes I get NRFX_ERROR_INTERNAL back from nrfx_uarte_rx call in blocking mode.
So I can process around 20...
Hello, I want to get information list about BLE GATT services and characteristics of a device.
I want to connect to a peripheral with a specific name, then get all metadata...
