Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi, I need some help on flashing the code to nRF52832 BLE module. I would like to mention that I am flashing the code to nRF module using ST-link v2 debugger with the help...
Hi,
I've encountered problem with app timer functions being called from different interrupt levels. Looks like no memory error returned is caused by collision in underlaying...
Dear Nordic,
I'm trying to determine why my nRF9160 cannot register on the Verizon network. Does Nordic have any tools which allow one to see the RRC messages between the...
I just try to connect to J2 port like I always used. I tested several cables and several USB ports, I'm using MAC os. 1. Power switch is ON
2. nRF Power source switch is...
Hi ,
We are building a ble mesh related project with nrf52840 soc with NRF MESH SDK 5 . After certain amount of development work we are facing issues related to synchronization...
Hi Team,
I am using the solar beacon code from Nordic playground github for some reason and I know this is not qualified. I observe that the receiver suddenly misses a train...
Hello! When configuring using the 'Configurtion Server' model, the number of network transfers cannot be configured correctly. If set to less than 2 "NRF Mesh Android App...
![image description]
hi,
I can able to flash but when i try to debug by putting breakpoints its not coming out of this APP_ERROR_CHECK(err_code) function, attached is...
I'm using " no.nordicsemi.android:ble" and " no.nordicsemi.android:ble-common" on a tablet app, and had created a virtual device(Polar HR) on my iPhone with LightBlue app...
1.) I used the sample code for BLE peripheral uart as template for my own project and modified it. I removed the nordic uart service "nus" and replaced it with a custom service...
Hello every,
Currently, I want to Device Firmware Update via Serial. I am using DFU Example for mesh to generate DFU packet. I only Update for 1 device via COM port, not...
Good morning,
I am trying to figure out how to write unit-tests using NRF Connect and Zephyr on Windows. Therefore I am trying to use unity as described here:
http:...
I have developed a custom board using nrf52840 IC and I need to use UART. For this I have two pins available P0.19 and P0.20 to be configured as RX and TX. I checked those...
