Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi, I'm trying to enroll my nrf9160DK preview kit in nrfcloud. I've successfully done it with my Thingy91, but in process of upgrading modem on Thingy91 with my DK I forgot...
hardware board : 52840dk_52840
sdk : ncs1.7.1
IDE: Visual Studio Code
in our OTA design , we have new image download and stored in a LTE module, since our application...
Hello,
I use ST's mcu + Atmel radio IC + nRF21540 as the FEM. Use Atmel radio IC's IO to control the TX_EN and RX_EN pins for nRF21540 automatically.
I want to change...
We plan to create a BLE central device to communicate with our peripheral devices. Both sides are based on the nRF52840 using SD140. As we've already developed the peripheral...
Hi,
I just turned off compiler optimizations with CONFIG_NO_OPTIMIZATIONS=y (before that, code was working correctly). After the change, I noticed that my program is stack...
Use Microsoft Visual Studio Installer Projects to create .msi for nRF-Command-Line-Tools-10.14.0-x64.exe and other .exe files, but an error message will appear during execution...
Hi,
Is it possible to create two separate USB devices on nRF5340? My application requires three USB classes: Audio, CDC and DFU. Currently I am using all three in a composite...
Hi to all!
I am trying to use the nrf5340 as a MCU for a IoT project. I need to create a ECC key using secp256r1 and save it in the nrf5340 for later use.
I am using...
Hello. Do you have working drivers for Windows 7? I see that this issue is being resolved with certain difficulties. I need working drivers that I can give to the client....
I succesfully flashed both direction finding samples to two different nRF5340dk's, but the rx board keeps rebooting afer the "Waiting for periodic sync lost..." message, while...
I currently need to solve pairing/bonding to be able to implement DFU with the buttonless bonded bootloader. So I need to handle bonding/pairing from my central device, controlled...
Hi nordic:
When I connected the Bluetooth, I encountered the occasional mobile phone unable to connect error. In most cases, it is normal, but occasionally the error of...
I have my external board with nrf52832, and I want to flash it via nrf52 DK.
However, I couldn't flash it when I used `nrfjprog` command such like;
nrfjprog --program...
