Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am running my application on nRF SDK 16.0 and SoftDevice 7.2.0 but had this problem since 15.2 and 6.1.1 respectively. I thought it was resolved in an update since this...
Hello Everyone, I am using nRF52840 and i have 2 SPI slaves (Sensor and EEPROM), the sensor spi clock is use 10 MHz and the EEPROM is 40MHz, sck、mosi、miso、ss are all different...
Once I try to connect nrf52-dk development board to a personal computer, using a micro USB cable, once the USB is detected from the PC, it instantly reboot without any reason...
Hi Nordic team,
My OS is Windows 7 X64. My dongle is PCA1000 (nRF51822)
I used master control panel to connect with my target board and control it many years ago. But...
Hi all, I want to use the nRF52832 as the connectivity chip to give a separate application chip access to at least BLE and ANT capability. Ideally, the nRF would expose a...
I am trying to get the board advertiser name from the advertising data received by another scanner board. I am using softdevice S140 version 7.2.0.
The server board name...
Hi,
We are using nRF52840 MCU in High voltage configuration with DCDC enabled. We would like to measure the battery voltage which varies between 3.7 to 4.2 using a simple...
Hello,
LED 5 blinks fastly and LED 1 blink slowly on nRF52840 and I cannot see the device via USB. I have previously flashed zephyr blinky example code few days back and...
Hello:
I'm relatively new and have been using 52832 DK for several months without any problems. It is a great product. As I gained experience, I've tried programming other...
I am using openOCD as the debugger for my nRF52 device. Nothing is working anymore. I am seeing errors like:
$ Error: Could not find MEM-AP to control the core
$ Error...
I am trying to use fstorage with softdevice, I have replicated the flash_storage_example in my project. I have enabled all thing in sdk_config.h like shown in the example...
Hey experts, We encountered a problem about project porting and using KEIL compiling. Here are detailed: Our products are using gcc+makefile method to compile and generate...
Hi all
have used the LIS2DH successfully with the nRF52810, now have upgraded to the nRF52832. The SPI lines are not working at all i.e. when I scope them they are all...
Hi all
Will like to know what is the most suitable programming language to program Nordic Microcontrollers and do Nordic provide any software training for developers regarding...
